ДСТУ EN 12663-2:2015 Железнодорожный транспорт. Структурные требования органов железнодорожного транспорта. Часть 2. Грузовые вагоны (EN 12663-2:2010, IDT)

Данный документ доступнен в тарифе «ВСЕ ВКЛЮЧЕНО»

У Вас есть вопросы по документу? Мы рады на них ответить!Перечень бесплатных документовОбнаружили ошибку в документе или на сайте? Пожалуйста, напишите нам об этом!Оставить заявку на документ

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(З питань придбання офіційного видання звертайтесь до національного органу стандартизації
(ДП «УкрНДНЦ»))

Наказ від 25.12.2015 № 205
Наказ від 28.12.2019 № 525

EN 12663-2:2010

Railway applications —
Structural requirements of railway vehicle bodies —
Part 2: Freight wagons

прийнято як національний стандарт
методом «підтвердження» за позначенням
Відповідає офіційному тексту

ДСТУ EN 12663-2:2015
(EN 12663-2:2010, IDT)

Залізничний транспорт.
Структурні вимоги органів залізничного транспорту.
Частина 2. Вантажні вагони

З наданням чинності від 2016–01–01
Поновлено чинність від 2020–01–01

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 Coordinate system

5 Load cases

5.1 Categories of freight wagons

5.2 Load cases

6 Design validation of vehicle body

6.1 General

6.2 Design validation of vehicle bodies made of steel

6.3 Design validation link to crashworthy buffer

7 Design validation of associated specific equipment

7.1 General

7.2 Static tests on the flaps of flat wagons

7.3 Strength of side and end walls

7.4 Strength of the roofs

7.5 Stresses imposed on the wagon floor by handling trolleys and road vehicles

7.6 Attachment of containers and swap bodies

7.7 Special wagons for the conveyance of containers

7.8 Strength of side doors

7.9 Strength of drop sides and ends at flat wagons and interchangeable flat/open wagons

7.10 Strength of stanchions

7.11 Strength of lockable partitions of sliding wall wagons

8 Buffing impact testing

8.1 General

8.2 Implementation

8.3 Assessment of the results

9 Validation programme

9.1 Objective

9.2 Validation programme for new design of vehicle body structures - Testing

9.3 Validation programme for evolved design of vehicle body structures

Annex ZA (informative) Relationship between this European Standard and the Essential Requirements of EC Directive 2008/57/EC

Bibliography

Полная версия документа доступна в тарифе «ВСЕ ВКЛЮЧЕНО».

Войти в Личный кабинет Подробнее о тарифах

БУДСТАНДАРТ Online