ДСТУ EN 14870-1:2018 Нефтяная и газовая промышленность. Изгибы, изготовленные методом индукционной сварки, фитинги и фланцы для трубопроводных транспортных систем. Часть 1. Изгибы, изготовленные методом индук...
ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ
Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(З питань придбання офіційного видання звертайтесь до національного органу стандартизації
(ДП «УкрНДНЦ»))
Наказ від 27.02.2018 № 65
EN 14870-1:2011
Petroleum and natural gas industries —
Induction bends, fittings and flanges
for pipeline transportation systems —
Part 1: Induction bends (ISO 15590-1:2009 modified)
прийнято як національний стандарт
методом «підтвердження» за позначенням
Відповідає офіційному тексту
ДСТУ EN 14870-1:2018
(EN 14870-1:2011, IDT; ISO 15590-1:2009, MOD)
Нафтова та газова промисловість.
Згини, виготовлені методом індукційного зварювання,
фітинги та фланці для трубопровідних транспортних систем.
Частина 1. Згини, виготовлені методом індукційного зварювання
З наданням чинності від 2018–04–01
Contents
Foreword
Introduction
1 Scope
2 Conformance
2.1 Units of measurement
2.2 Rounding
2.3 Compliance to standard
3 Normative references
4 Terms and definitions
5 Symbols and abbreviated terms
5.1 Symbols
5.2 Abbreviated terms
6 Designation
7 Pressure rating and design
8 Information that shall be supplied by the purchaser
8.1 General information
8.2 Additional information
8.3 Information on the mother pipe
9 Manufacturing
9.1 Mother pipe
9.2 Qualification test bend
9.3 Production bending
9.4 Post-bending heat treatment
9.5 Forming and sizing after bending
9.6 Strip/plate end welds
9.7 Jointers and girth welds
9.8 End preparation
10 Testing and inspection
10.1 General requirements
10.2 Extent of testing and inspection
10.3 Chemical composition
10.4 Physical testing
10.5 Non-destructive testing
10.6 Dimensions
10.7 Gauging
10.8 Hydrostatic testing
11 Inspection document
12 Marking
Annex A (normative) Manufacturing procedure specification
A.1 Introduction
A.2 Manufacturing procedure specification
Annex B (normative) PSL 2S bends ordered for sour service
B.1 Introduction
B.2 Additional information that shall be supplied by the purchaser
B.3 Manufacturing
B.4 Testing and inspection
B.5 Hard spots
B.6 Inspection
B.7 Non-destructive inspection
Bibliography
Полная версия документа доступна в тарифе «ВСЕ ВКЛЮЧЕНО».