ДСТУ ISO 15519-2:2018 Требования к схемам для перерабатывающей промышленности. Часть 2. Измерение и контроль (ISO 15519-2:2015, IDT)

Данный документ доступнен в тарифе «ВСЕ ВКЛЮЧЕНО»

У Вас есть вопросы по документу? Мы рады на них ответить!Перечень бесплатных документовОбнаружили ошибку в документе или на сайте? Пожалуйста, напишите нам об этом!Оставить заявку на документ

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(З питань придбання офіційного видання звертайтесь до національного органу стандартизації
(ДП «УкрНДНЦ»))

Наказ від 14.11.2018 № 412

ISO 15519-2:2015

Specifications for diagrams for process industry —
Part 2: Measurement and control

прийнято як національний стандарт
методом «підтвердження» за позначенням
Відповідає офіційному тексту

ДСТУ ISO 15519-2:2018
(ISO 15519-2:2015, IDT)

Вимоги до схем для переробної промисловості.
Частина 2. Вимірювання та контролювання

З наданням чинності від 2019–01–01

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms, definitions, and abbreviated terms

3.1 Terms related to control

3.2 Document types

3.3 Abbreviated terms

4 Documentation and process control principles

4.1 Introduction

4.2 Diagram types, structures, and life cycle aspects

4.3 Process control interrelations

4.4 Information exchange between process and control systems

5 Exchange of process control information

5.1 Symbols for information exchange

5.2 Letter codes

5.3 Reference designation

6 Representation in general

6.1 General

6.2 Signal lines

6.3 Graphical symbols

7 Representation in diagrams

7.1 Introduction

7.2 Process flow diagram, PFD

7.3 Process and instrumentation diagram, PID

7.4 Process control diagram, PCD

7.5 Typical diagrams, TYD

Annex A (informative) Graphical symbols for connections main process equipment, measurement, actuation, and control

Annex B (informative) Examples of representation of measurement, control, and actuation tasks

Annex C (informative) Diagram examples

Annex D (informative) Information exchange between process and control system

Annex E (informative) Relationship between terms for closed loop control, measurement, actuation, etc.

Bibliography

Полная версия документа доступна в тарифе «ВСЕ ВКЛЮЧЕНО».

Войти в Личный кабинет Подробнее о тарифах

БУДСТАНДАРТ Online