ДСТУ EN 13001-3-1:2014 Краны. Общие положения конструирования. Часть 3-1. Предельные состояния и доказательство прочности стальных конструкций (EN 13001-3-1:2012+A1:2013, IDT)

Данный документ доступнен в тарифе «ВСЕ ВКЛЮЧЕНО»

У Вас есть вопросы по документу? Мы рады на них ответить!Перечень бесплатных документовОбнаружили ошибку в документе или на сайте? Пожалуйста, напишите нам об этом!Оставить заявку на документ

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Міністерство економічного розвитку і торгівлі України

Наказ від 29.12.2014 № 1479

EN 13001-3-1:2012+A1:2013

Cranes - General Design -
Part 3-1: Limit States and proof competence of steel structure

прийнято як національний стандарт
методом «підтвердження» за позначенням
Відповідає офіційному тексту

ДСТУ EN 13001-3-1:2014
(EN 13001-3-1:2012+A1:2013, IDT)

Крани. Загальні положення конструювання.
Частина 3-1. Граничні стани і доказ міцності сталевих конструкцій

З наданням чинності від 2016–01–01

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms, definitions, symbols and abbreviations

3.1 Terms and definitions

3.2 Symbols and abbreviations

4 General

4.1 Documentation

4.2 Materials for structural members

4.3 Bolted connections

4.4 Pinned connections

4.5 Welded connections

4.6 Proof of competence for structural members and connections

5 Proof of static strength

5.1 General

5.2 Limit design stresses and forces

5.3 Execution of the proof

6 Proof of fatigue strength

6.1 General

6.2 Limit design stresses

6.3 Stress histories

6.4 Execution of the proof

6.5 Determination of the limit design stress range

7 Proof of static strength of hollow section girder joints

8 Proof of elastic stability

8.1 General

8.2 Lateral buckling of members loaded in compression

8.3 Buckling of plate fields subjected to compressive and shear stresses

8.4 Execution of the proof

Annex A (informative) Limit design shear force Fv,Rd per bolt and per shear plane for multiple shear plane connections

Annex B (informative) Preloaded bolts

Annex C (normative) Design weld stresses σW,Sd and τW,Sd

Annex D (normative) Values of slope constant m and characteristic fatigue strength Δσc, Δτc

Annex E (normative) Calculated values of limit design stress ranges ΔσRd and ΔσRd,1

Annex F (informative) Evaluation of stress cycles (example)

Annex G (informative) Calculation of stiffnesses for connections loaded in tension

Annex H (informative) Hollow Sections

Annex I (informative) Selection of a suitable set of crane standards for a given application

Annex ZA (informative) Relationship between this European Standard and the Essential Requirements of EU Directive 2006/42/EC

Bibliography

Полная версия документа доступна в тарифе «ВСЕ ВКЛЮЧЕНО».

Войти в Личный кабинет Подробнее о тарифах

БУДСТАНДАРТ Online