ДСТУ EN 12999:2019 Краны. Краны-манипуляторы (EN 12999:2011 + А2:2018, IDT)
ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ
Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(ДП «УкрНДНЦ»)
Наказ від 06.06.2019 № 142
EN 12999:2011 + A2:2018
Cranes — Loader cranes
прийнято як національний стандарт
методом підтвердження за позначенням
ДСТУ EN 12999:2019
(EN 12999:2011 + А2:2018, IDT)
Крани. Крани-маніпулятори
З наданням чинності від 2020-01-01
Відповідає офіційному тексту
З питань придбання
офіційного видання звертайтесь
до
національного органу стандартизації
(ДП «УкрНДНЦ» http://uas.org.ua)
Contents
European foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and terminology
3.1 Terms and definitions
3.2 Terminology
4 List of significant hazards
5 Safety requirements and/or safety measures
5.1 General
5.2 Structural calculation
5.3 Stress analysis
5.4 Mechanical arrangements
5.5 Hydraulic system
5.6 Limiting and indicating devices
5.7 Controls
5.8 Control stations
5.9 Electrical systems
5.10 Installation
6 Verification of the safety requirements and/or measures
6.1 General
6.2 Testing and test procedures
6.3 Noise emission measurement
7 Information for use
7.1 General
7.2 Manuals
7.3 Marking
Annex A (informative) Examples of configurations and mountings
Annex B (informative) Stress history parameter s and stress history classes S
Annex C (informative) Explanatory notes
Annex D (informative) Examples of dangerous movement
Annex E (normative) Symbols for working and setting-up functions
Annex F (informative) Control system - Preferred vertical layout for controls operated from the ground
Annex G (informative) Control system - Horizontal layout order
Annex H (informative) Control levers for high seats and remote controls
Annex I (not used)
Annex J (normative) Cabins fitted on vehicle mounted loader cranes up to a net lifting moment of 250 kNm
Annex K (informative) Examples of raised control stations
Annex L (normative) Raised control stations - Measures regarding hand rails and hand holds, ladders and steps
Annex M (informative) Installation of a loader crane on a vehicle
Annex N (informative) Selection of a suitable set of crane standards for a given application
Annex ZA (informative) Relationship between this European Standard and the Essential Requirements of EU Directive 2006/42/EC
Bibliography
Полная версия документа доступна в тарифе «ВСЕ ВКЛЮЧЕНО».