ДСТУ IEC 60945:2019 Оборудование и системы морской навигации и радиосвязи. Общие требования. Методы испытания и требуемые результаты испытания (IEC 60945:2002, IDT)

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(ДП «УкрНДНЦ»)

Наказ від 05.12.2019 № 403

IEC 60945:2002

Maritime navigation and radiocommunication equipment and systems —
General requirements — Methods of testing and required test results

прийнято як національний стандарт
методом підтвердження за позначенням

ДСТУ IEC 60945:2019
(IEC 60945:2002, IDT)

Обладнання та системи морської навігації та радіозв’язку. Загальні вимоги.
Методи випробування та необхідні результати випробування

З наданням чинності від 2020-01-01

Відповідає офіційному тексту

З питань придбання офіційного видання звертайтесь
до національного органу стандартизації
(ДП «УкрНДНЦ» http://uas.org.ua)

CONTENTS

FOREWORD

INTRODUCTION

1 Scope

2 Normative references

3 Definitions and abbreviations

3.1 Definitions

3.2 Abbreviations used in this standard

3.3 IMO performance standards

4 Minimum performance requirements

4.1 General

4.2 Design and operation

4.3 Power supply

4.4 Durability and resistance to environmental conditions

4.5 Interference

4.6 Safety precautions

4.7 Maintenance

4.8 Equipment manuals

4.9 Marking and identification

5 Methods of testing and required test results

5.1 General

5.2 Test conditions

5.3 Test results

6 Operational checks (all equipment categories)

6.1 Ergonomics and HMI

6.2 Hardware

6.3 Software

6.4 Inter-unit connection

7 Power supply - Methods of testing and required test results

7.1 Extreme power supply

7.2 Excessive conditions

7.3 Power supply short-term variation

7.4 Power supply failure

8 Durability and resistance to environmental conditions - Methods of testing and required test results

8.1 General

8.2 Dry heat

8.3 Damp heat

8.4 Low temperature

8.5 Thermal shock (portable equipment)

8.6 Drop (portable equipment)

8.7 Vibration (all equipment categories)

8.8 Rain and spray (exposed equipment)

8.9 Immersion

8.10 Solar radiation (portable equipment)

8.11 Oil resistance (portable equipment)

8.12 Corrosion (salt mist) (all equipment categories)

9 Electromagnetic emission - Methods of testing and required test results

9.1 General 

9.2 Conducted emissions (all equipment categories except portable)

9.3 Radiated emissions from enclosure port (all equipment categories except submerged)

10 Immunity to electromagnetic environment - Methods of testing and required test results

10.1 General

10.2 Radio receiver equipment

10.3 Immunity to conducted radio frequency disturbance

10.4 Immunity to radiated radiofrequencies (all equipment categories except submerged)

10.5 Immunity to fast transients on a.c. power, signal and control lines (all equipment categories except portable)

10.6 Immunity to surges on a.c. power lines (all equipment categories except portable)

10.7 Immunity to power supply short-term variation (all equipment categories except portable) 

10.8 Immunity to power supply failure (all equipment categories except portable)

10.9 Immunity to electrostatic discharge (all equipment categories except submerged) 

11 Special purpose tests - Methods of testing and required test results

11.1 Acoustic noise and signals (all equipment intended for installation in wheelhouses and bridge wings) 

11.2 Compass safe distance (all equipment categories except submerged) 

12 Safety precautions - Methods of testing and required test results (all equipment categories) 

12.1 Protection against accidental access to dangerous voltages

12.2 Electromagnetic radio frequency radiation

12.3 Emission from visual display unit (VDU)

12.4 X-radiation

13 Maintenance (all equipment categories)

14 Equipment manuals (all equipment categories)

15 Marking and identification (all equipment categories) 

Annex A (normative) IMO Resolution A.694(17) Adopted on 6 November 1991

Annex B (informative) Environmental conditions for ships

Annex C (informative) EMC requirements for ships

Annex D (informative) Examples of equipment by environmental class

Annex E (informative) Test Report

Annex F (informative) Cross-references between the requirements of IMO Resolution A.694 and the tests/checks in this standard

Annex G (informative) Summary of significant changes to test requirements from Edition 3 of IEC 60945

Bibliography