ДСТУ EN 16713-1:2020 Частные бассейны. Системы водоснабжения. Часть 1. Системы фильтрации. Требования и методы испытаний (EN 16713-1:2016, IDT)

Данный документ доступнен в тарифе «ВСЕ ВКЛЮЧЕНО»

У Вас есть вопросы по документу? Мы рады на них ответить!Перечень бесплатных документовОбнаружили ошибку в документе или на сайте? Пожалуйста, напишите нам об этом!Оставить заявку на документ

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(ДП «УкрНДНЦ»)

Наказ від 21.12.2020 № 475

EN 16713-1:2016

Domestic swimming pools - Water systems - Part 1: Filtration systems -
Requirements and test methods

прийнято як національний стандарт
методом «підтвердження» за позначенням

ДСТУ EN 16713-1:2020
(EN 16713-1:2016, IDT)

Приватні басейни. Системи водопостачання. Частина 1. Системи
фільтрації. Вимоги та методи випробування

З наданням чинності від 2021–01–01

Відповідає офіційному тексту

З питань придбання офіційного видання звертайтесь
до національного органу стандартизації
(ДП «УкрНДНЦ» http://uas.org.ua)

Contents

European foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 Requirements

4.1 General

4.2 Maximum filter flow rate

4.3 Filter media

4.4 Maximum operating pressure (MOP)

4.5 Turbidity reduction efficiency

4.6 Retention capacity

4.7 Backwashing/Replacement/Cleaning Criteria

4.8 Construction requirements

5 Pressure resistance (pressure filter)

5.1 General

5.2 Static pressure resistance test

5.3 Cyclic pressure variation resistance test

5.4 Determination of the burst pressure

6 Pressure resistance (negative pressure filter)

6.1 General

6.2 Test pressure

6.3 Static negative pressure resistance test

6.4 Cyclic negative pressure variation resistance test

6.5 Determination of the negative collapsing pressure

7 Test methods for filtration efficiency

7.1 Principle

7.2 Turbidity reduction and contaminant retained mass

7.3 Filtration efficiency and retention capacity

8 Instructions and operation

8.1 General principles

8.2 Point-of-purchase information

8.3 User's manual

8.4 Maintenance advice

Annex A (informative) Harmonized pump curves for the filtration efficiency and retention capacity tests

Annex B (informative) Example of test report verifying the resistance to fatigue caused by cyclic pressure or negative pressure variations

Annex C (informative) Environmental aspects

Bibliography

Полная версия документа доступна в тарифе «ВСЕ ВКЛЮЧЕНО».

Войти в Личный кабинет Подробнее о тарифах

БУДСТАНДАРТ Online