ДСТУ IEC/TR 61000-3-7:2012 Электромагнитная совместимость. Часть 3-7. Оценка норм эмиссии для подключения флуктуационных установок к электроснабжающим системам среднего, высокого и сверхвысокого напряжения (I...
ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ
Наказом Міністерства економічного розвитку і торгівлі України
від 28.05.2012 № 640
Європейський стандарт
IEC/TR 61000-3-7:2008
en: Electromagnetic compatibility (EMC) – Part 3-7: Limits – Assessment of emission limits for
the connection of fluctuating installations to MV, HV and EHV power systems
прийнято як національний стандарт методом «підтвердження»
мовою оригіналу за національним позначенням
ДСТУ IEC/TR 61000-3-7:2012
uk: Електромагнітна сумісність. Частина 3-7. Оцінення норм емісії для підключення
флуктуаційних установок до електропостачальних систем середньої,
високої та
надвисокої напруги
З наданням чинності в Україні від 2012-08-01
CONTENTS
FOREWORD
INTRODUCTION
ACKNOWLEDGMENT
1 Scope
2 Normative references
3 Terms and definitions
4 Basic EMC concepts related to voltage fluctuations
4.1 Compatibility levels
4.2 Planning levels
4.3 Illustration of EMC concepts
4.4 Emission levels
5 General principles
5.1 Stage 1: simplified evaluation of disturbance emission
5.2 Stage 2: emission limits relative to actual system characteristics
5.3 Stage 3: acceptance of higher emission levels on a conditional basis
5.4 Responsibilities
6 General guidelines for the assessment of emission levels
6.1 Point of evaluation
6.2 Definition of flicker emission level
6.3 Assessment of flicker emission levels
6.4 Declared system short circuit power or impedance
6.5 General guidelines for assessing the declared system impedance
7 General summation law
8 Emission limits for fluctuating installations connected to MV systems
8.1 Stage 1: simplified evaluation of disturbance emission
8.2 Stage 2: emission limits relative to actual system characteristics
8.3 Stage 3: acceptance of higher emission levels on a conditional basis
8.4 Summary diagram of the evaluation procedure
9 Emission limits for fluctuating installations connected to HV or EHV systems
9.1 Stage 1: simplified evaluation of disturbance emission
9.2 Stage 2: emission limits relative to actual system characteristics
9.3 Stage 3: acceptance of higher emission levels on a conditional basis
10 Rapid voltage changes
10.1 General considerations
10.2 Compatibility level
10.3 Planning levels
10.4 Emission limits
10.5 Assessment procedure for evaluation against planning levels & emission limits
Annex A (informative) Pst = 1 curves and numerical data for 230 V and 120 V applications
Annex B (informative) Guidelines on the assessment of flicker transfer coefficient
Annex C (informative) Example of reallocation of global contributions and planning levels considering transfer coefficients
Annex D (informative) The use of the severity indicators Ast and Alt to simplify calculations
Annex E (informative) Pre-connection and post-connection assessment of emission for Pst
Annex F (informative) Addition of Pst from different busbars
Annex G (informative) Examples of case studies
Annex H (informative) List of symbols and subscripts
Bibliography
Полная версия документа доступна в тарифе «ВСЕ ВКЛЮЧЕНО».