ДСТУ EN 61000-4-8:2012 Электромагнитная совместимость. Часть 4-8. Методики испытания и измерения. Испытание на невосприимчивость к магнитным полям частоты сети (EN 61000-4-8:2010, IDT)

Данный документ доступнен в тарифе «ВСЕ ВКЛЮЧЕНО»

У Вас есть вопросы по документу? Мы рады на них ответить!Перечень бесплатных документовОбнаружили ошибку в документе или на сайте? Пожалуйста, напишите нам об этом!Оставить заявку на документ

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Наказом Міністерства економічного розвитку і торгівлі України
від 28.05.2012 № 640

Європейський стандарт

EN 61000-4-8:2010

en: Electromagnetic compatibility (EMC) - Part 4-8: Testing and measurement techniques -
Power frequency magnetic field immunity test

прийнято як національний стандарт
методом «підтвердження» за позначенням
Відповідає офіційному тексту

ДСТУ EN 61000-4-8:2012
(EN 61000-4-8:2010,IDT)

uk: Електромагнітна сумісність. Частина 4-8. Методики випробування та вимірювання.
Випробування на несприйнятливість до магнітних полів частоти мережі

З наданням чинності в Україні від 2012–08–01

CONTENTS

INTRODUCTION

1 Scope

2 Normative references

3 Terms and definitions

4 General

5 Test levels

6 Test equipment

6.1 General

6.2 Test generator

6.2.1 Current source

6.2.2 Characteristics and performances of the test generator for different inductive coils

6.2.3 Verification of the characteristics of the test generator

6.3 Inductive coil

6.3.1 Field distribution

6.3.2 Characteristics of the inductive standard coils 1 m x 1 m and 1 m x 2,6 m

6.3.3 Characteristics of the inductive coils for table top and floor standing equipment

6.3.4 Measurement of the inductive coil factor

6.4 Test and auxiliary instrumentation

6.4.1 Test instrumentation

6.4.2 Auxiliary instrumentation

7 Test set-up

7.1 Test set-up components

7.2 Ground (reference) plane for floor standing equipment

7.3 Equipment under test

7.4 Test generator

7.5 Inductive coil

8 Test procedur

8.1 General

8.2 Laboratory reference conditions

8.2.1 General

8.2.2 Climatic conditions

8.2.3 Electromagnetic conditions

8.3 Carrying out the test

9 Evaluation of the test results

10 Test report

Annex A (normative) Inductive coil calibration method

Annex B (normative) Characteristics of the inductive coils

Annex C (informative) Selection of the test levels

Annex D (informative) Information on power frequency magnetic field strength

Bibliography

Полная версия документа доступна в тарифе «ВСЕ ВКЛЮЧЕНО».

Войти в Личный кабинет Подробнее о тарифах

БУДСТАНДАРТ Online