ДСТУ EN 13201-4:2016 Уличное освещение. Часть 4. Методы измерения световых характеристик (EN 13201-4:2015, IDT)

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство «Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(З питань придбання офіційного видання звертайтесь до національного органу стандартизації
(ДП «УкрНДНЦ»))

Наказ від 22.08.2016 № 243

EN 13201-4:2015

Road lighting - Part 4: Methods of measuring lighting performance

прийнято як національний стандарт
методом «підтвердження» за позначенням

ДСТУ EN 13201-4: 2016
(EN 13201-4:2015, IDТ)

Вуличне освітлення.
Частина 4. Методи вимірювання світлових характеристик.

З наданням чинності від 2016-09-01

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 Symbols and abbreviations

5 Preliminary information of road lighting system measurement

5.1 Aims of measurements

5.2 Measurement procedures and selection of photometric instruments

5.3 Measurement uncertainty evaluation

5.4 Measured zones

5.5 Measured parameters

5.6 General information regarding measurements during the lifetime of the lighting installation

5.7 Comparison with requirements

6 Measurement conditions

6.1 Ageing of lamps and luminaires before measurements

6.2 Stabilization after switch-on

6.3 Climatic conditions

6.4 Road conditions

6.5 Extraneous light and obstruction of light

7 Photometric measurements

7.1 Location of grid points

7.2 Measurement of luminance

7.3 Measurement of illuminance

7.4 Measurement of Edge Illuminance Ratio (Rei)

7.5 Measurement of the threshold increment (/Vi)

8 Measurement of non-photometric parameters

8.1 General

8.2 Supply voltage

8.3 Temperature and humidity

8.4 Geometric data

8.5 Instruments for non-photometric measurements

9 Test report

Annex A (informative) Evaluation of tolerances in road lighting installation design

A.1 Tolerance analysis

A.2 Parameters to be considered in the tolerance analysis

A.3 Mathematical model for tolerance evaluations

A.4 Modelling the tolerance analysis

Annex B (informative) Important particular parameters

B.1 General

B.2 Particular luminance and uniformity

B.3 Use of extended uniformity

B.4 Evaluation of extended uniformities

Annex C (normative) Conventions for symbols of photometric quality parameters

Annex D (normative) Guidelines for measurement systems for adaptive road lighting

Annex E (informative) Measurements for investigation of discrepancies between photometric measures and design expectation

Annex F (informative) Measurement uncertainty evaluation)

F.1 Luminance measurements

F.2 Illuminance measurements

Annex G (informative) Practical information

G.1 Genera

G.2 Measurement precautions

G.3 Measurement organization

Annex H (informative) Example of report

H.1 Premise

H.2 General test information

H.3 Geometrical data

H.4 Road surface data

H.5 Lamp and luminaire data

H.6 Electricity supply

H.7 Environmental conditions

H.8 Condition of installation

H.9 Measuring devices data

H.10 Photometric measuring devices characteristics

H.11 Measurement grid

H.12 Light monitoring record

H.13 Specific information for dynamic measurements

Bibliography