ДСТУ EN 15283-2:2019 Плиты гипсовые с волокнистой арматурой. Определения, требования и методы испытаний. Часть 2. Гипсокартон с фиброволокном (EN 15283-2:2008 + A1:2009, IDT)
ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ
Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(З питань придбання офіційного видання звертайтесь до національного органу стандартизації
(ДП «УкрНДНЦ»))
Наказ від 18.12.2019 № 442
EN 15283-2:2008 + A1:2009
Gypsum boards with fibrous reinforcement —
Definitions, requirements and test methods —
Part 2: Gypsum fibre boards
прийнято як національний стандарт
методом «підтвердження» за позначенням
Відповідає офіційному тексту
ДСТУ EN 15283-2:2019
(EN 15283-2:2008 + A1:2009, IDT)
Плити гіпсові з волокнистою арматурою.
Визначення, вимоги та методи випробування.
Частина 2. Гіпсокартон з фіброволокном
З наданням чинності від 2020–01–01
Contents
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
4.1 Mechanical characteristics
4.2 Fire behaviour
4.3 Acoustic properties
4.4 Water vapour permeability/water vapour resistance (expressed as water vapour resistance factor) question for the mandate
4.5 Thermal resistance (expressed as thermal conductivity)
4.6 Dangerous substances
4.7 Dimensions and tolerances
4.8 Additional requirements for gypsum fibre boards with reduced surface water absorption types GF-W1 and GF-W2
4.9 Additional requirements for gypsum fibre boards with reduced water absorption rate type GF-H
4.10 Additional requirements for gypsum fibre boards with enhanced density type GF-D
4.11 Additional requirements for gypsum fibre boards with enhanced surface hardness type GF-I
4.12 Impact resistance
5 Test methods
5.1 Sampling
5.2 Determination of width
5.3 Determination of length
5.4 Determination of thickness
5.5 Determination of squareness
5.6 Determination of flexural strength (bending strength)
5.7 Determination of deflection under load
5.8 Determination of surface water absorption
5.9 Determination of total water absorption
5.10 Determination of density
5.11 Determination of surface hardness of the board
5.12 Determination of shear strength (strength of board/substructure connection)
6 Evaluation of conformity
6.1 General
6.2 Initial type testing
6.3 Factory production control
7 Designation of gypsum fibre boards
8 Marking, labelling and packaging
Annex A (informative) Sampling procedure for testing
Annex B (normative) Mounting and fixing for testing according to EN 13823 (SBI)
Annex ZA (informative) Clauses of this European Standard addressing the provisions of EU Construction Products Directive
Bibliography
Полная версия документа доступна в тарифе «ВСЕ ВКЛЮЧЕНО».