ДСТУ EN ISO 13588:2019 Неруйнівний контроль зварних швів. Ультразвуковий контроль. Застосування автоматизованого методу фазованих решіток (EN ISO 13588:2019, IDT; ISO 13588:2019, IDT)

Даний документ доступний у тарифі «ВСЕ ВРАХОВАНО»

У Вас є питання стосовно документа? Ми раді на них відповісти!Перелік безкоштовних документівПомітили помилку в документі або на сайті? Будь ласка, напишіть нам про це!Залишити заявку на документ

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(З питань придбання офіційного видання звертайтесь до національного органу стандартизації
(ДП «УкрНДНЦ»))

Наказ від 23.12.2019 № 480

EN ISO 13588:2019

Non-destructive testing of welds — Ultrasonic testing —
Use of automated phased array technology
(ISO 13588:2019)

прийнято як національний стандарт
методом «підтвердження» за позначенням
Відповідає офіційному тексту

ДСТУ EN ISO 13588:2019
(EN ISO 13588:2019, IDT; ISO 13588:2019, IDT)

Неруйнівний контроль зварних швів. Ультразвуковий контроль.
Застосування автоматизованого методу фазованих решіток

З наданням чинності від 2020-01-01

Contents

Foreword

1 Scope

2 Normative references

3 Terms and definitions

4 Testing levels

5 Information required prior to testing

5.1 Items to be defined prior to procedure development

5.2 Specific information required by the operator before testing

5.3 Written test procedure

6 Requirements for personnel and test equipment

6.1 Personnel qualifications

6.2 Test equipment

7 Preparation for testing

7.1 Volume to be tested

7.2 Verification of the test setup

7.3 Scan increment setting

7.4 Geometry considerations

7.5 Preparation of scanning surfaces

7.6 Temperature

7.7 Couplant

8 Testing of base material

9 Range and sensitivity settings

9.1 Settings

9.2 Checking of the settings

9.3 Reference blocks

10 Equipment checks

11 Procedure qualification

12 Weld testing

13 Data storage

14 Interpretation and analysis of phased array data

14.1 General

14.2 Assessing the quality of the phased array data

14.3 Identification of relevant indications

14.4 Classification of relevant indications

14.5 Determination of location

14.6 Determination of length and height

14.7 Evaluation against acceptance criteria

15 Test report

Annex A (informative) Typical reference blocks and reference reflectors

Annex В (informative) Illustrations of possible signals to be used

Bibliography

Повна версія документа доступна в тарифі «ВСЕ ВРАХОВАНО».

Увійти в Особистий кабінет Детальніше про тарифи

БУДСТАНДАРТ Online