ДСТУ EN ISO 5136:2014 Акустика. Визначення звукової потужності, випромінюваної в повітропровід вентиляторами. Метод випробовування з вимірюванням в повітропроводі (EN ISO 5136:2009, IDT)

Даний документ доступний у тарифі «ВСЕ ВРАХОВАНО»

У Вас є питання стосовно документа? Ми раді на них відповісти!Перелік безкоштовних документівПомітили помилку в документі або на сайті? Будь ласка, напишіть нам про це!Залишити заявку на документ

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Міністерство економічного розвитку і торгівлі України

Наказ від 29.12.2014 № 1479

EN ISO 5136:2009

Acoustics. Determination of sound power radiated into a duct
by fans and other air-moving devices. In-duct method

прийнято як національний стандарт
методом «підтвердження» за позначенням
Відповідає офіційному тексту

ДСТУ EN ISO 5136:2014
(EN ISO 5136:2009, IDT)

Акустика. Визначення звукової потужності, випромінюваної в повітропровід вентиляторами.
Метод випробовування з вимірюванням в повітропроводі

З наданням чинності від 2016–01–01

Contents

Foreword

Introduction

1 Scope

1.1 General

1.2 Types of sound source

2 Normative references

3 Terms, definitions and symbols

4 Uncertainty of the measurement method

5 Test facilities and instrumentation

5.1 General requirements

5.2 Duct specifications

5.3 Instrumentation

5.4 System calibration

6 Test arrangement

6.1 Sampling tube mounting

6.2 Microphone position

6.3 Operating condition control equipment

7 Test procedure

7.1 Operating conditions

7.2 Sound pressure level readings

7.3 Measurements with and without flow straightener on the outlet side

7.4 Inlet side measurements — Large fans: installation category D (according to ISO 5801:1997)

8 Calculations

8.1 Average sound pressure level

8.2 Sound power level

9 Information to be recorded

10 Information to be reported

Annex A (normative) Determination of the combined mean flow velocity and modal correction C3,4

Annex B (normative) Determination of the signal-to-noise ratio of sound vs. turbulent pressure fluctuation in the test duct

Annex C (normative) Computational procedures for calculating the A-weighted sound power level from one-third-octave-band sound power levels

Annex D (informative) Example of calculation of C3,4 for a given duct diameter and mean flow velocity

Annex E (informative) Guidelines for the design and construction of an anechoic termination

Annex F (informative) Evaluation of performance of anechoic terminations

Annex G (informative) Sampling tube information

Annex H (informative) Test method for small ducted fans

Annex I (informative) Test method for large ducted fans

Annex J (informative) Measurement of the swirl component

Bibliography

Повна версія документа доступна в тарифі «ВСЕ ВРАХОВАНО».

Увійти в Особистий кабінет Детальніше про тарифи

БУДСТАНДАРТ Online