ДСТУ EN 12831-3:2017 Енергоефективність будівель. Метод розрахунку проектного теплового навантаження. Частина 3. Теплове навантаження систем гарячого водопостачання та характеристика потреб, Модулі M8-2, M8-3...
ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ
Державне підприємство «Український
науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та
якості»
(ДП
«УкрНДНЦ»)
Наказ від 13.12.2017 № 414
EN 12831-3:2017
Energy performance of
buildings —
Method for calculation of the design heat load —
Part 3: Domestic
hot water systems heat load and characterisation of needs, Module M8-2, M8-3
прийнято як національний
стандарт
методом «підтвердження» за позначенням
Відповідає офіційному тексту
ДСТУ EN 12831-3:2017
(EN 12831-3:2017, IDT)
Енергоефективність
будівель.
Метод
розрахунку проектного теплового навантаження.
Частина 3. Теплове навантаження
систем гарячого водопостачання та характеристика потреб, Модулі
M8-2, M8-3
З наданням чинності від 2017-12-15
Contents
European foreword
Introduction
1 Scope
2 Normative references
3 Ternis and definitions
4 Symbols and abbreviations
4.1 Symbols
4.2 Subscripts
5 Description of the methods
5.1 General description of the method for sizing domestic hot water systems
5.2 General description of the methods for calculating the energy needs for domestic hot water
6 Calculation procedures
6.1 Output data
6.2 Calculation time steps
6.3 Input data
6.3.1 General
6.3.2 Product data
6.3.3 System design data
6.3.4 Operating data and boundary
6.3.5 Other data
6.4 Calculation procedure for sizing domestic hot water systems
6.4.1 Calculation of the energy needs curve for DHW
6.4.2 Energy supply
6.4.3 Procedure for dimensioning the DHW system
6.5 Calculation procedure for determining the energy needs for domestic hot water
6.5.1 Energy need for domestic hot water based on draw-off or load profiles
6.5.2 Energy need for domestic hot water based on volume required
6.5.3 Energy need for domestic hot water based directly on floor area
6.5.4 Tabulated energy need for domestic hot water
7 Quality control
8 Compliance check
Annex A (normative) Template for input data
A.1 Load profiles
A.2 Parameters to calculate energy needs
A.3 Parameters for sizing DHW systems
A.4 General values
Annex B (informative) Default input data
B.1 Load profiles
B.2 Parameters to calculate energy needs
B.3 Parameters for sizing DHW systems
B.4 General values
Bibliography
Повна версія документа доступна в тарифі «ВСЕ ВРАХОВАНО».