ДСТУ EN 1520:2019 Елементи збірні армовані з легкого бетону з пористим заповнювачем і відкритою структурою, з конструкційним і неконструкціонним армуванням (EN 1520:2011, IDT)

Даний документ доступний у тарифі «ВСЕ ВРАХОВАНО»

У Вас є питання стосовно документа? Ми раді на них відповісти!Перелік безкоштовних документівПомітили помилку в документі або на сайті? Будь ласка, напишіть нам про це!Залишити заявку на документ

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(ДП «УкрНДНЦ»)

Наказ від 23.12.2019 № 487

EN 1520:2011

Prefabricated reinforced components
of lightweight aggregate concrete with open structure
with structural or non-structural reinforcement

прийнято як національний стандарт
методом підтвердження за позначенням

ДСТУ EN 1520:2019
(EN 1520:2011, IDT)

Елементи збірні армовані з легкого бетону
з пористим заповнювачем і відкритою структурою,
з конструкційним і неконструкціонним армуванням

З наданням чинності від 2020–01–01

Відповідає офіційному тексту

З питань придбання офіційного видання звертайтесь
до національного органу стандартизації
(ДП «УкрНДНЦ» http://uas.org.ua)

Contents

Foreword

1 Scope

2 Normative references

3 Terms, definitions, symbols and abbreviations

3.1 Terms and definitions

3.2 Symbols

3.3 Abbreviations

3.4 Units

4 Properties and requirements of materials

4.1 Constituents

4.2 Lightweight aggregate concrete parameters

4.3 Reinforcement steel

5 Properties and requirements of components

5.1 General

5.2 Types of components

5.3 Detailing, technical requirements, and declared properties

5.4 Additional requirements for roof and floor components and beams

5.5 Additional requirements for wall components

5.6 Durability

6 Evaluation of conformity

6.1 Introduction

6.2 Initial type-testing of the component

6.3 Factory production control

6.4 Initial inspection of the factory and the factory production control

6.5 Surveillance, assessment and approval of the factory production control

6.6 Actions to be taken in the event of non-conformity

7 Basis for design

7.1 Design methods

7.2 Limit states

7.3 Actions

8 Marking, labelling and designation

8.1 Standard designation

8.2 Additional information on accompanying documents

Annex A (normative) Design of components by calculation

Annex B (informative) Design of components by testing

Annex C (informative) Recommended values for partial safety factor

Annex ZA (informative) Provisions for the CE marking of prefabricated components of lightweight aggregate concrete with open structure with structural or non-structural reinforcement under the EU Construction Product Directive

Bibliography

Повна версія документа доступна в тарифі «ВСЕ ВРАХОВАНО».

Увійти в Особистий кабінет Детальніше про тарифи

БУДСТАНДАРТ Online