ДСТУ EN 1917:2019 Колодязі оглядові та шахти контрольні з бетону, залізобетону та бетону, армованого сталевим волокном (EN 1917:2002, IDT)

Даний документ доступний у тарифі «ВСЕ ВРАХОВАНО»

У Вас є питання стосовно документа? Ми раді на них відповісти!Перелік безкоштовних документівПомітили помилку в документі або на сайті? Будь ласка, напишіть нам про це!Залишити заявку на документ

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(З питань придбання офіційного видання звертайтесь до національного органу стандартизації
(ДП «УкрНДНЦ»))

Наказ від 26.12.2019 № 511

EN 1917:2002

Concrete manholes and inspection chambers,
unreinforced, steel fibre and reinforced

прийнято як національний стандарт
методом «підтвердження» за позначенням
Відповідає офіційному тексту

ДСТУ EN 1917:2019
(EN 1917:2002, IDT)

Колодязі оглядові та шахти контрольні з бетону,
залізобетону та бетону, армованого сталевим волокном

З наданням чинності від 2020–01–01

Contents

Foreword

1 Scope

2 Normative references

3 Terms, definitions and symbols

3.1 Terms and definitions

3.2 Symbols

4 General requirements

4.1 Materials

4.2 Concrete

4.3 Units

5 Special requirements

5.1 Steel fibre concrete units

5.2 Reinforced concrete units

6 Test methods for finished products

6.1 General

6.2 Joint profiles

6.3 Reinforcement

6.4 Crushing strength of chamber and shaft units

6.5 Vertical strength of reducing units and capping units

6.6 Watertightness

6.7 Water absorption

6.8 Concrete strength in base units, capping unit walls, adjusting units and certain tapers

6.9 Installed steps

7 Conformity evaluation

7.1 General

7.2 Product evaluation procedures

8 Marking

Annex A (normative) Test method for crushing strength of chamber and shaft units

Annex B (normative) Test methods for vertical strength of reducing units and capping units

Annex C (normative) Test methods for watertightness

Annex D (normative) Test method for water absorption

Annex E (normative) Test methods for installed steps

Annex F (normative) Manufacturer's quality assurance system

Annex G (normative) Sampling procedures for inspection of finished products

Annex H (normative) Sampling procedures for continuous inspection of crushing strength, vertical strength and watertightness (vertical unit hydrostatic)

Annex I (normative) Tasks for a product certification body

Annex J (normative) Procedure for unreinforced concrete chamber and shaft units where routine (continuous) inspection of crushing strength is primarily to minimum crushing load

Annex ZA (informative) Clauses of this European Standard addressing essential requirements or other provisions of EU Directives

Bibliography

Повна версія документа доступна в тарифі «ВСЕ ВРАХОВАНО».

Увійти в Особистий кабінет Детальніше про тарифи

БУДСТАНДАРТ Online