ДСТУ EN 61167:2022 Металогалогенні лампи. Характеристики (EN 61167:2018, IDT; IEC 61167:2018, MOD)



ДСТУ EN 61167:2022
(EN 61167:2018, IDT; IEC 61167:2018, MOD)

Металогалогенні лампи. Характеристики

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

FOREWORD

INTRODUCTION

1 Scope

2 Normative references

3 Terms and definitions

4 Lamp requirements

4.1 General

4.2 Marking

4.3 Dimensions

4.4 Caps

4.5 Starting and warm-up characteristics

4.6 Electrical characteristics

4.7 Photometric characteristics

4.8 Colour characteristics.

4.9 Lumen maintenance and life

5 Information for ballast, ignitor and luminaire design

6 Datasheets

6.1 General principles of numbering sheets

6.2 Lists of data sheets

6.3 List of maximum lamp outline sheets (construction according to IEC 61126)

Annex A (normative) Method of measuring lamp starting and warm-up characteristics

Annex В (normative) Method of measuring electrical and photometrical characteristics (lamps for operation on 50 Hz or 60 Hz supply frequencies)

Annex C (normative) Method of test for lumen maintenance and life

Annex D (informative) Information for luminaire design

Annex E (normative) Method of measuring electrical and photometrical characteristics on low frequency square wave reference ballast

Annex F (normative) Spectral analysis of power ripple: calculation procedure for amplitude spectrum ratio and guidance

Annex G (informative) Low frequency square wave operation

Annex H (informative) Information for ballast design

Annex J (informative) ILCOS codes

Annex К (informative) Method of measuring the bulb, pinch, reflector and base temperatures of metal halide lamps for luminaire design

Bibliography