ДСТУ EN IEC 62485-5:2022 Вимоги щодо безпеки для вторинних батарей і батарейних установок. Частина 5. Безпечна експлуатація стаціонарних літій-іонних батарей (EN IEC 62485-5:2021, IDT; IEC 62485-5:2020, IDT)



ДСТУ EN IEC 62485-5:2022
(EN IEC 62485-5:2021, IDT; IEC 62485-5:2020, IDT)

Вимоги щодо безпеки для вторинних батарей і батарейних установок.
Частина 5. Безпечна експлуатація стаціонарних літій-іонних батарей

 

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions and abbreviated terms

3.1 Terms and definitions

3.2 Abbreviated terms

4 Protection against electric shock

4.1 General

4.2 Basic protection

4.3 Fault protection

4.4 Protective measure: extra-low voltage provided by SELV, PELV and FELV

5 Disconnection and separation

6 Prevention of short-circuits and protection from other effects of electric current

6.1 General

6.2 Short-circuits

6.3 Maintenance instructions

6.4 Leakage currents

7 Provision against hazards

7.1 General

7.2 Charging modes

7.3 Overcharging or overdischarging under fault conditions

7.4 Prevention of electrostatic discharges when working with batteries

8 Provision against hazards posed by chemical substances

8.1 General

8.2 Initial actions in case of hazardous chemical release

8.3 Battery accessories and maintenance tools

9 Accommodation, housing

9.1 General

9.2 Specific requirements for separate battery rooms

9.3 Specific requirements for the specially separated areas in rooms accommodating electrical equipment

9.4 Battery enclosures

9.5 Working on or near batteries

9.6 Accommodation of lithium ion batteries in combination with batteries containing aqueous electrolyte (e.g. lead-acid and NiCd batteries) in the same room

10 Charge current requirements

10.1 General

10.2 Superimposed ripple current

10.3 Maximum ripple current

11 Identification labels, warning notices and instructions for use, installation and maintenance

11.1 Warning labels and notices in rooms

11.2 Identification labels or marking on cell, module, battery pack or battery system

11.3 Instructions for use, installation and maintenance.\

12 Transportation, storage and environmental aspects

13 Inspection and monitoring

14 EMC for stationary application

Annex A (informative) Charging methods and modes of operation

Annex В (normative) Electromagnetic compatibility (EMC)

Annex C (informative) Cell behaviour inside and outside of operating region

Bibliography