ДСТУ EN ISO 10440-1:2022 Нафтова, нафтохімічна та газова промисловість. Об’ємні компресори роторного типу. Частина 1. Технологічні компресори (EN ISO 10440-1:2007, IDT; ISO 10440-1:2007, IDT)



ДСТУ EN ISO 10440-1:2022
(EN ISO 10440-1:2007, IDT; ISO 10440-1:2007, IDT)

Нафтова, нафтохімічна та газова промисловість.
Об’ємні компресори роторного типу. Частина 1.
Технологічні компресори

 
   
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 General

4.1 Pressure design code

4.2 Unit responsibility

4.3 Units of measurement

4.4 Statutory requirements

5 Basic design

5.1 General

5.2 Pressure casing

5.3 Casing connections

5.4 External forces and moments

5.5 Rotating elements

5.6 Shaft seals

5.7 Dynamics

5.8 Bearings

5.9 Bearing housings

5.10 Lube-oil and seal-oil systems

5.11 Materials

5.12 Nameplates and rotation arrows

5.13 Quality

6 Accessories

6.1 Drivers

6.2 Couplings and guards

6.3 Mounting plates

6.4 Controls and instrumentation

6.5 Piping

6.6 Intercoolers and aftercoolers

6.7 Inlet air filters

6.8 Inlet separators

6.9 Pulsation suppressors/silencers for dry screw compressors

6.10 Special tools

7 Inspection, testing and preparation for shipment

7.1 General

7.2 Inspection

7.3 Testing

7.4 Preparation for shipment

8 Vendor’s data

8.1 General

8.2 Proposals

8.3 Contract data

Annex A (informative) Typical datasheets

Annex B (informative) Nomenclature for rotary-type positive-displacement compressors

Annex C (normative) Forces and moments

Annex D (normative) Procedure for determination of residual unbalance

Annex E (normative) Typical schematics for pressurized oil systems for flooded screw
compressors

Annex F (informative) Materials and their specifications for rotary compressors

Annex G (informative) Typical mounting plate arrangements

Annex H (informative) Inspector’s checklist

Annex I (informative) Typical vendor drawing and data requirements

Bibliography