ДСТУ EN 15502-1:2017 Котли опалювальні на газовому паливі. Частина 1. Загальні вимоги та випробування (EN 15502-1:2012+А1:2015, IDT)

ДСТУ EN 15502-1:2017
(EN 15502-1:2012+ А1:2015, IDT)

Котли опалювальні на газовому паливі. Частина 1. Загальні вимоги та випробування

 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms, definitions and symbols

4 Classification

5 Construction

6 Electrical safety

7 Controls

8 Operational requirements

9 Useful efficiencies

10 Electric auxiliary energy

11 Risk assessment

12 Marking and instructions

13 Requirements for Eco-design Regulation (No 813/2013) and Energy Labelling Regulation (No 811/2013)

Annex A (informative) - Properties of carbon and stainless steels

Annex B (normative) - Minimum requirements for cast iron

Annex C (normative) - Parts in aluminium and aluminium alloys

Annex D (normative) - Parts in copper or copper alloys

Annex E (normative) - Minimum thicknesses for rolled parts

Annex F (normative) - Nominal minimum thicknesses of boiler sections of cast materials under water pressure

Annex G (normative) - Parameters for welded joints and welding processes

Annex H (informative) - Composition of the gas circuit

Annex I (informative) - Compilation of the test conditions for the various gas families

Annex J (informative) - Calculation of conversions of NOx

Annex K (informative) - Example of calculation of the weighting factors NOx

Annex L (informative) - Practical method of calibrating the test rig to enable the heat loss Dp to be determined

Annex M (informative) - Means of determining the ignition time at full rate

Annex N (informative) - Determination of the heat losses from the test rig of the indirect method and the contributions of the circulating pump of the test rig

Annex O (informative) - Example of a risk assessment method

Annex P (informative) - Examples of risk assessment with a method described in Annex O

Annex Q (informative) - Realisation of a protective measure

Annex R (informative) - Overall classification of a basic risk

Annex S (informative) - Not exhaustive list of classification examples

Annex T (normative) - Correction for the determined efficiency in the low water temperature test of low temperature boilers (LTB) and condensing boilers (CB)

Annex U (informative) - Use of test gases

Annex V (informative) - Standards intended to be replaced by this standard in combination with the relevant part 2

Annex W (informative) - Alternative Method for the determination of the nominal heat input or the maximum and minimum heat input (according to 8.4.1) for appliances using a pneumatic gas/air ratio control system

Annex AA (normative) - Product Information related to Eco-design Regulation and Labelling Regulation

Annex BB (normative) - Product label for boilers required by the Labelling Regulation 811/2013

Annex CC (normative) - Product label for packages required by the Labelling Regulation 811/2013

Annex DD (normative) - Calculation of the seasonal space heating energy efficiency of a package of space heater, temperature control and solar

Annex ZA (informative) - Clauses of this European Standard addressing essential requirements or provisions of EU Directive 2009/142/EC, 'Directive relating to Appliances burning gaseous fuels (codified version)' (GAD)

Annex ZB (informative) - Clauses of this European Standard addressing the methods for the verification of the efficiency of the EU Directive 92/42/EEC, relating to the efficiency of new hot boilers with an output of 4 - 400 kW

Annex ZC (informative) - Relationship between this European Standard and the Requirements of COMMISSION REGULATION (EU) No 813/2013 of 2 August 2013 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for space heaters and combination heaters

Annex ZD (informative) - Relationship between this European Standard and the Requirements of COMMISSION DELEGATED REGULATION (EU) No 811/2013 of 18 February 2013 supplementing Directive 2010/30/EU of the European Parliament and of the Council with regard to the energy labelling of space heaters, combination heaters, packages of space heater, temperature control and solar device and packages of combination heater, temperature control and solar device

Bibliography