ДСТУ EN ISO 13385-1:2018 Технічні вимоги до геометричних параметрів продукції (GPS). Прилади для лінійних та кутових вимірювань. Частина 1. Штангенциркулі. Проектні та метрологічні характеристики (EN ISO 1338...
ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ
Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(
(ДП «УкрНДНЦ»))
Наказ від 18.12.2018 № 502
EN ISO 13385-1:2011
Geometrical product specifications (GPS) —
Dimensional measuring equipment —
Part 1: Callipers; Design and metrological characteristics
(ISO 13385-1:2011)
прийнято як національний стандарт
методом «підтвердження» за позначенням
ДСТУ EN ISO 13385-1:2018
(EN ISO 13385-1:2011, IDT; ISO 13385-1:2011, IDT)
Технічні вимоги до геометричних параметрів продукції (GPS).
Прилади для лінійних та кутових вимірювань.
Частина 1. Штангенциркулі.
Проектні та метрологічні характеристики
З наданням чинності від 2019–01–01
Contents
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Design characteristics
4.1 General design and nomenclature
4.2 Dimensions
4.3 Types of indicating devices
4.4 Measuring faces
5 Metrological characteristics
5.1 General
5.2 Effect of slider locking
5.3 Maximum permissible error of indication (limited by MPE)
5.4 MPE and MPL for a number of metrological characteristics
6 Indication in product documentation and data sheets
7 Proof of conformance with specifications
7.1 General
7.2 Measurement standards for the calibration of metrological characteristics
8 Marking
Annex A (informative) Error tests
Annex B (informative) Advice on application
Annex C (informative) Examples of different types of callipers
Annex D (informative) Examples of types of measurements
Annex E (informative) Data sheet (example)
Annex F (informative) Calibration of metrological characteristics
Annex G (informative) Relation to the GPS matrix model
Bibliography
Повна версія документа доступна в тарифі «ВСЕ ВРАХОВАНО».