ДСТУ EN 13001-3-1:2019 Крани. Загальні положення конструювання. Частина 3-1. Граничні стани та доказ міцності сталевих конструкцій (EN 13001-3-1:2012 + A2:2018, IDT)
ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ
Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(ДП «УкрНДНЦ»)
Наказ від 21.08.2019 № 271
EN 13001-3-1:2012 + A2:2018
Cranes — General Design —
Part 3-1: Limit States and proof
competence of steel structure
прийнято як національний стандарт
методом підтвердження за позначенням
ДСТУ EN 13001-3-1:2019
(EN 13001-3-1:2012 + A2:2018, IDT)
Крани. Загальні положення конструювання.
Частина 3-1. Граничні стани та доказ
міцності сталевих конструкцій
З наданням чинності від 2020–01–01
до
національного органу стандартизації
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)
Contents
1 Scope
2 Normative references
3 Terms ,definitions, symbols and abbreviations
3.1 Terms and definitions
3.2 Symbols and abbreviations
4 General
4.1 Documentation
4.2 Materials for structural members
4.3 Bolted connections
4.4 Pinned connections
4.5 Welded connections
4.6 Proof of competence for structural members and connections
5 Proof of static strength
5.1 General
5.2 Limit design stresses and forces
5.3 Execution of the proof
6 Proof of fatigue strength
6.1 General
6.2 Limit design stresses
6.3 Stress histories
6.4 Execution of the proof
6.5 Determination of the limit design stress range
7 Proof of static strength of hollow section girder joints
8 Proof of elastic stability
8.1 General
8.2 Lateral buckling of members loaded in compression
8.3 Buckling of plate fields subjected to compressive and shear stresses
8.4 Execution of the proof
Annex A (informative) Limit design shear force Fv,Rd per bolt and per shear plane for multiple shear plane connections
Annex B (informative) Preloaded bolts
Annex C (normative) Design weld stresses σw,Sd and Ƭw,Sd
Annex D (normative) Values of slope constant m and characteristic fatigue strength ∆σc, ∆Ƭc
Annex E (normative) Calculated values of limit design stress ranges ∆σRd and ∆σRd,1
Annex F (informative) Evaluation of stress cycles (example)
Annex G (informative) Calculation of stiffnesses for connections loaded in tension
Annex H (informative) Hollow Sections
Annex I (informative) Selection of a suitable set of crane standards for a given application
Annex ZA (informative) Relationship between this European Standard and the Essential Requirements of EU Directive 2006/42/EC
Повна версія документа доступна в тарифі «ВСЕ ВРАХОВАНО».