ДСТУ EN 55016-4-2:2022 Технические условия для устройств и методов измерения радиопомех и невосприимчивости. Часть 4-2. Неопределенности, статистика и моделирование ограничений. Неопределенность измерительных...

ДСТУ EN 55016-4-2:2022
(EN 55016-4-2:2011, IDT; CISPR 16-4-2:2011, IDT)

Технічні умови для пристроїв і методів вимірювання радіоперешкод і
несприйнятливості. Частина 4-2. Невизначеності, статистика та
моделювання обмежень. Невизначеність вимірювальних приладів

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms, definitions, symbols and abbreviations

3.1 Terms and definitions

3.2 Symbols

3.3 Abbreviations

4 Compliance criterion for the MIU

4.1 General

4.2 Compliance assessment

5 Conducted disturbance measurements

5.1 Conducted disturbance measurements at a mains port using an AMN (see also B.1)

5.2 Conducted disturbance measurements at a mains port using a VP (see also B.2)

5.3 Conducted disturbance measurements at a telecommunication port using an AAN (Y-network) (see also B.3)

5.4 Conducted disturbance measurements at a telecommunication port using a CVP (see also B.4)

5.5 Conducted disturbance measurements at a telecommunication port using a CP (see also B.5)

6 Disturbance power measurements (see also C.1)

6.1 Measurand for disturbance power measurements

6.2 Symbols of input quantities specific for disturbance power measurements

6.3 Input quantities to be considered for disturbance power measurements

7 Radiated disturbance measurements in the frequency range 30 MHz to 1 000 MHz

7.1 Radiated disturbance measurements at an OATS or in a SAC (see also D.1)

7.2 Radiated disturbance measurements in a FAR (see also D.2)

8 Radiated disturbance measurements in the frequency range 1 GHz to 18 GHz (see also E.1)

8.1 Measurand for radiated disturbance measurements in a FAR (FSOATS)

8.2 Symbols of input quantities specific for radiated disturbance measurements

8.3 Input quantities to be considered for radiated disturbance measurements in a FAR

Annex A (informative) Basis for U_cispr values in Table 1, general information and  rationale for input quantities common to all measurement methods

Annex В (informative) Basis for U_cispr values in Table 1, uncertainty budgets and rationale for conducted disturbance measurements

Annex C (informative) Basis for U_cispr values in Table 1 - Disturbance power measurements

Annex D (informative) Basis for U_cispr values in Table 1 - Radiated disturbance measurements from 30 MHz to 1 000 M Hz

Annex E (informative) Basis for U_cispr values in Table 1 - Radiated disturbance measurements from 1 GHz to 18 GHz

Bibliography