ДСТУ EN 60880:2022 Атомные электростанции. Контрольно-измерительные приборы и системы управления важные для безопасности. Аспекты программного обеспечения для компьютерных систем, выполняющих функции категори...

ДСТУ EN 60880:2022
(EN 60880:2009, IDT; IEC 60880:2006, IDT)

Атомні електростанції. Контрольно-вимірювальні прилади
та системи управління, важливі для безпеки. Аспекти програмного
забезпечення для комп’ютерних систем, що виконують функції категорії A

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Introduction

1 Scope and object

2 Normative references

3 Terms and definitions

4 Symbols and abbreviations

5 General requirements for software projects

5.1 General

5.2 Software types

5.3 Software development approach

5.4 Software project management

5.5 Software quality assurance plan

5.6 Configuration management

5.7 Software security

6 Software requirements

6.1 Specification of software requirements

6.2 Self-supervision

6.3 Periodic testing

6.4 Documentation

7 Design and implementation

7.1 Principles for design and implementation

7.2 Language and associated translators and tools

7.3 Detailed recommendations

7.4 Documentation

8 Software Verification

8.1 Software verification process

8.2 Software verification activities

9 Software aspects of system integration

9.1 Software aspects of system integration plan

9.2 System integration

9.3 Integrated system verification

9.4 Fault resolution procedures

9.5 Software aspects of integrated system verification report

10 Software aspects of system validation

10.1 Software aspects of the system validation plan

10.2 System validation

10.3 Software aspects of the system validation report

10.4 Fault resolution procedures

11 Software modification

11.1 Modification request procedure

11.2 Procedure for executing a software modification

11.3 Software modification after delivery

12 Software aspects of installation and operation

12.1 On-site installation of the software

12.2 On-site software security

12.3 Adaptation of the software to on-site conditions

12.4 Operator training

13 Defences against common cause failure due to software

13.1 General

13.2 Design of software against CCF

13.3 Sources and effects of CCF due to software

13.4 Implementation of diversity

13.5 Balance of drawbacks and benefits connected with the use of diversity

14 Software tools for the development of software

14.1 Introduction

14.2 Selection of tools

14.3 Requirements for tools

15 Qualification of pre-developed software

15.1 General

15.2 General requirements

15.3 Evaluation and assessment process

15.4 Requirements for integration in the system and modification of PDS

Annex A (normative) Software safety life cycle and details of software requirements

Annex B (normative) Detailed requirements and recommendations for design and implementation

Annex C (informative) Example of application oriented software engineering (software development with application-oriented language)

Annex D (informative) Language, translator, linkage editor

Annex E (informative) Software verification and testing

Annex F (informative) Typical list of software documentation

Annex G (informative) Considerations of CCF and diversity

Annex H (informative) Tools for production and checking of specification, design and implementation

Annex I (informative) Requirements concerning pre-developed software (PDS)

Annex J (informative) Correspondence between IEC 61513 and this standard