ДСТУ EN 1992-4:2022 Еврокод 2. Проектирование бетонных конструкций. Часть 4. Проектирование креплений для использования в бетоне (EN 1992-4:2018, IDT)

ДСТУ EN 1992-4:2022
(EN 1992-4:2018, IDT)

Єврокод 2. Проєктування бетонних конструкцій.
Частина 4. Проєктування кріплень для використання в бетоні

 
 
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

European foreword

1 Scope

1.1 General

1.2 Type of fasteners and fastening groups

1.3 Fastener dimensions and materials

1.4 Fastener loading

1.5 Concrete strength and type

1.6 Concrete member loading

2 Normative references

3 Terms, definitions, symbols and abbreviations

3.1 Terms and definitions

3.2 Symbols and abbreviations

4 Basis of design

4.1 General

4.2 Required verifications

4.3 Design format

4.4 Verification by the partial factor method

4.5 Project specification

4.6 Installation of fasteners

4.7 Determination of concrete condition

5 Durability

6 Derivation of forces acting on fasteners - analysis

6.1 General

6.2 Headed fasteners and post-installed fasteners

6.3 Anchor channels

6.4 Forces assigned to supplementary reinforcement

7 Verification of ultimate limit state

7.1 General

7.2 Headed and post-installed fasteners

7.3 Fasteners in redundant non-structural systems

7.4 Anchor channels

8 Verification of ultimate limit state for fatigue loading

8.1 General

8.2 Derivation of forces acting on fasteners - analysis

8.3 Resistance

9 Verification for seismic loading

9.1 General

9.2 Requirements

9.3 Derivation of forces acting on fasteners

9.4 Resistance

10 Verification for fire resistance

11 Verification of serviceability limit state

Annex A (normative) Additional rules for verification of concrete elements due to loads applied by fastenings

Annex В (informative) Durability

Annex C (normative) Design of fastenings under seismic actions