ДСТУ EN ISO 16230-1:2016 Машины и тракторы сельскохозяйственные. Высоковольтные электрические и электронные компоненты и системы. Часть 1. Общие требования (EN ISO 16230-1:2015, IDT; ISO 16230-1:2015)

ДСТУ EN ISO 16230-1:2016
(EN ISO 16230-1:2015, IDT; ISO 16230-1:2015)

Машини та трактори сільськогосподарські. Високовольтні електричні та електронні
компоненти і системи. Частина 1. Загальні вимоги

 
   
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

European foreword

Endorsement notice

Annex ZA (informative) Relationship between this International Standard and the Essential Requirements of EU Directive 2006/42/EC

Foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 General requirements

4.1 Standards

4.2 Component selection

5 Protection of persons against electric shock

5.1 General

5.2 Protection against direct contact

5.3 Connectors

5.4 Protection against indirect contact

5.5 Protection by potential equalization (equipotential bonding)

5.6 Isolation resistance requirements

5.7 Parasitic coupling

5.8 Test procedure for the protection against electric shock

6 Additional requirements for electrical sockets connecting to implements or attachments

6.1 Mated connection — General

6.2 Connect/Disconnect

6.3 Protection of electrical equipment

7 Conductors and cables used in higher voltage distribution — General requirements

7.1 Identification Colours

7.2 Identification of conductors for multicore cable

7.3 Creepage and clearance distances

7.4 Cable and wire insulation

7.5 Cross-sectional area

7.6 Multicore cables

7.7 Wiring that flexes

7.8 Flame retardancy

7.9 Protection of cables

8 Wiring practices — General

8.1 Fastening and clamping

8.2 Routing

9 System requirements

9.1 Power on/power off procedure

9.2 Fault modes (indication)

10 Marking and symbols

11 Information for use

12 Service literature

12.1 General

12.2 Reduction of electrical hazards while servicing

12.3 Special procedures

13 Technical documentation

13.1 General

13.2 Information to be provided

13.3 Overview diagrams and function diagrams

13.4 Circuit diagrams

13.5 Parts list

Annex A (informative) List of hazards

Bibliography