ДСТУ IEC 60282-2:2016 Предохранители плавкие высоковольтные. Часть 2. Плавкие предохранители выхлопного типа (IEC 60282-2:2008, IDT)

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(   
(ДП «УкрНДНЦ»))

Наказ від 07.09.2016 № 266

ІЕС 60282-2:2008

High-voltage fuses — Part 2: Expulsion fuses

прийнято як національний стандарт
методом «підтвердження» за позначенням
 

ДСТУ ІЕС 60282-2:2016
 (ІЕС 60282-2:2008, IDT)

Запобіжники плавкі високовольтні.
Частина 2. Плавкі запобіжники вихлопного типу

З наданням чинності від 2016-09-15

CONTENTS

FOREWORD

1 Scope

2 Normative references

3 Terms and definitions

3.1 Electrical characteristics

3.2 Fuses and their component parts (see Figure 1)

3.3 Additional terms

4 Service conditions

4.1 Normal service conditions

4.2 Special service conditions

5 Classification and designation

5.1 Classification

5.2 Fuse-link speed designation

6 Ratings

6.1 General

6.2 Rated voltage

6.3 Rated current

6.4 Rated frequency

6.5 Rated breaking capacity

6.6 Rated insulation level (of a fuse or fuse-base)

7 Standard conditions of use and behaviour

7.1 Standard conditions of use with respect to breaking capacity

7.2 Standard conditions of behaviour with respect to breaking capacity

7.3 Time-current characteristics

7.4 Temperature and temperature rise

7.5 Electromagnetic compatibility

7.6 Mechanical requirements (for distribution fuse-cutouts)

8 Type tests

8.1 Conditions for performing the tests

8.2 List of type tests and test reports

8.3 Common test practices for all type tests

8.4 Dielectric tests

8.5 Temperature-rise tests

8.6 Breaking tests

8.7 Time-current characteristics tests

8.8 Mechanical tests (for distribution fuse-cutouts)

8.9 Artificial pollution tests

9 Special tests

9.1 General

9.2 Lightning surge impulse withstand test

10 Acceptance tests

11 Markings and information

11.1 Identifying markings

11.2 Information to be given by the manufacturer

12 Application guide

12.1 Object

12.2 General

12.3 Application

12.4 Operation

12.5 Information about special requirements not covered by this standard

Annex A (informative) Reasons for the selection of breaking-test values

Annex B (informative) Typical dimensions for fuse-links having an inner arc-quenching tube and used in distribution fuse-cutouts and open-link cutouts

Annex C (informative) Operating rods for fuses

Bibliography