ДСТУ EN 62271-101:2016 Устройства контрольные распределительные высоковольтные. Часть 101. Испытания синтетическим методом (EN 62271-101:2013, IDT)

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(   
(ДП «УкрНДНЦ»))

Наказ від 07.09.2016 № 266

EN 62271-101:2013

High-voltage switchgear and controlgear — Part 101: Synthetic testing

прийнято як національний стандарт
методом «підтвердження» за позначенням
 

ДСТУ EN 62271-101:2016
(EN 62271-101:2013, IDТ)

Пристрої контрольні розподільчі високовольтні.
Частина 101. Випробування синтетичним методом

З наданням чинності від 2016-09-15

CONTENTS

1 Scope

2 Normative references

3 Terms and definitions

4 Synthetic testing techniques and methods for short-circuit breaking tests

4.1 Basic principles and general requirements for synthetic breaking test methods

4.2 Synthetic test circuits and related specific requirements for breaking tests

4.3 Three-phase synthetic test methods

5 Synthetic testing techniques and methods for short-circuit making tests

5.1 Basic principles and general requirements for synthetic making test methods

5.2 Synthetic test circuit and related specific requirements for making tests

6 Specific requirements for synthetic tests for making and breaking performance related to the requirements of 6.102 through 6.111 of IEC 62271-100:2008

Annex A (informative) Current distortion

Annex B (informative) Current injection methods

Annex C (informative) Voltage injection methods

Annex D (informative) Skeats or duplicate transformer circuit

Annex E (normative) Information to be given and results to be recorded for synthetic tests

Annex F (normative) Synthetic test methods for circuit-breakers with opening resistors

Annex G (informative) Synthetic methods for capacitive-current switching

Annex H (informative) Re-ignition methods to prolong arcing

Annex I (normative) Reduction in di/dt and TRV for test duty T100a

Annex J (informative) Three-phase synthetic test circuits

Annex K (normative) Test procedure using a three-phase current circuit and one voltage circuit

Annex L (normative) Splitting of test duties in test series taking into account the associated TRV for each pole-to-clear

Annex M (normative) Tolerances on test quantities for type tests

Annex N (informative) Typical test circuits for metal-enclosed and dead tank circuit-breakers

Annex O (informative) Combination of current injection and voltage injection methods

Bibliography