ДСТУ EN 60968:2015 Лампы со встроенным пускорегулирующим устройством для общего освещения. Требования безопасности (EN 60968:2015, IDT)

ДСТУ EN 60968:2015
(EN 60968:2015, IDT)

Лампи з умонтованим пускорегулювальним пристроєм для загального освітлення.
Вимоги щодо безпеки

 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

1 Scope

2 Normative references

3 Terms and definitions

4 General requirements and general test requirements

5 Marking

5.1 Lamp marking

5.2 Additional marking

5.3 Compliance of marking

5.4 Locations where marking is required (See Table 1)

6 Interchangeability, mass and bending moment

6.1 Interchangeability

6.2 Bending moment and mass imparted by the lamp at the lampholder

7 Protection against electric shock

8 Insulation resistance and electric strength

8.1 General

8.2 Insulation resistance

8.3 Electric strength

9 Mechanical strength

9.1 General

9.2 Torsion resistance

9.2.1 Torsion resistance of unused lamps

9.2.2 Torsion resistance of lamps after a defined time of usage

9.3 Axial strength of Edison caps

10 Cap temperature rise

11 Resistance to heat

12 Resistance to flame and ignition

13 Fault conditions

13.1 General requirements

13.2 Test conditions

13.3 Test setup for non-starting lamp

14 Creepage distances and clearances

15 Lamp end of life

15.1 General requirements

15.2 Test setup

15.3 Compliance

16 Photobiological safety

16.1 UV radiation

16.2 Other photobiological effects

17 Abnormal operation

18 Test conditions for dimmable and three-way lamps

19 Whole production assessment

20 Collation of type test verification

21 Information for luminaire design

Annex A (informative) Whole production assessment

Annex B (informative) Information for luminaire design

Bibliography