ДСТУ EN 13035-3:2014 Машины и установки для выработки, обработки и переработки плоского стекла. Требования безопасности. Часть 3. Режущие машины (EN 13035-3:2003+A1:2009, EN 13035-3:2003+A1:2009/AC:2010, IDT)



ДСТУ EN 13035-3:2014
(EN 13035-3:2003+A1:2009, IDT)

Машини та установки для вироблення, оброблення та перероблення плаского скла.
Вимоги безпеки. Частина 3. Різальні машини

 

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

0 Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 List of significant hazards

5 Safety requirements and/or protective measures

5.1 Common requirements

5.2 Additional special safety requirements for flat glass cutting tables where access is not intended

5.3 Additional special safety requirements for flat glass cutting tables where access is intended

6 Verification of safety requirements and/or protective measures

7 Information for use

Annex A (normative) Perimeter fencing

Annex B (normative) Photo-electric guarding

Annex C (normative) Photo-electric guarding with barrier rail

Annex D (normative) Fixed distance guard

Annex E (normative) Photo-electric guarding

Annex F (normative) Reflex photo-electric sensors (single light beam scanners) and push-away bars

Annex G (normative) Stopping operation by safety measures

Annex H (informative) Electrical interlocking of movable guards

Annex I (informative) Danger zones on cutting machines

Annex J (informative) Synopsis of possible methods of safeguarding according to 5.2 and 5.3

Annex K (normative) Noise-test code

Annex ZA (informative) Relationship between this European Standard and the Essential Requirements of EU Directive 98/37/EC, amended by 98/79/EC

Annex ZB (informative) Relationship between this European Standard and the Essential Requirements of EU Directive 2006/42/EC

Bibliography