ДСТУ EN IEC 55015:2020 Нормы и методы измерения характеристик радиобурь электрического осветительного и аналогичного оборудования (EN IEC 55015:2019, IDT; CISPR 15:2018, IDT)

ДСТУ EN IEC 55015:2020
(EN IEC 55015:2019, IDT; CISPR 15:2018, IDT)

Норми та методи вимірювання характеристик радіозбурень
електричного освітлювального та аналогічного обладнання

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

1 Scope

2 Normative references

3 Terms, definitions and abbreviated terms

3.1 General

3.2 General terms and definitions

3.3 Terms and definitions related to equipment

3.4 Terms and definitions related to interfaces and ports

3.5 Abbreviated terms

4 Limits

4.1 General

4.2 Frequency ranges

4 3 Limits and methods for the assessment of wired network ports

4.4 Limits and methods for the assessment of local wired ports

4.5 Limits and methods for the assessment of the enclosure port

5 Application of the limits

5.1 General

5.2 Identification of the interfaces subject to test

5.3 Application of limits to the interfaces

6 Product specific limit application requirements

6.1 General

6.2 Passive EUT

6.3 Rope lights

6.4 Modules

7 Operating and test conditions of the EUT

7.1 General

7.2 Switching

7.3 Supply voltage and frequency

7.4 Rated lamp load and light regulation

7.5 Operating modes

7.6 Ambient conditions

7.7 Lamps

7.8 Stabilization times

7.9 Operation and loading of wired interfaces

8 Methods of measurement of conducted disturbances

8.1 General

8.2 Measurement instrumentation and methods

8.3 Electrical power supply interface disturbance measurement

8 4 Disturbance measurement of wired network interfaces other than power supply

8.5 Local wired port disturbance measurement

9 Methods of measurement of radiated disturbances

9.1 General

9.2 Intentional wireless transmitters

9.3 Measurement instrumentation and methods

10 Compliance with this document

11 Measurement uncertainty

12 Test report

Annex A (normative) Product specific application notes referring to particular measurement set-ups or operating conditions

Annex В (normative) Test arrangements for conducted disturbance measurements

Annex C (normative) Test arrangements for radiated disturbance measurements

Annex D (informative) Examples of application of limits and test methods

Annex E (informative) Statistical considerations in the determination of EMC compliance of mass-produced products

Bibliography