ДСТУ EN ISO 20430:2022 Машины для производства резины и пластмасс. Термопластавтоматы. Требования по безопасности (EN ISO 20430:2020, IDT; ISO 20430:2020, IDT)



ДCТУ EN ISO 20430:2022
(EN ISO 20430:2020, IDT; ISO 20430:2020, IDT)

Машини для виробництва гуми та пластмас.
Термопластавтомати. Вимоги щодо безпеки

 

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms, definitions and abbreviated terms

3.1 Terms and definitions

3.2 Abbreviated terms

4 Safety requirements and/or protective/risk reduction measures

4.1 Basic requirements

4.2 Mould area

4.3 Clamping mechanism area or area behind the movable platen

4.4 Area of movement of cores and ejectors and their drive mechanisms outside the mould and/or clamping mechanism areas

4.5 Nozzle area

4.6 Injection unit area

4.7 Discharge area

4.8 Safety requirements and/or protective measures against hazards not associated with a particular area of the machine

4.9 Additional safety requirements and/or protective measures associated with specific machine design

5 Verification of the safety requirements and/or protective measures

6 Information for use

6.1 General

6.2 Instruction handbook

6.3 Marking

6.4 Warning signs

6.5 Warning devices

Annex A (informative) List of significant hazards

Annex В (normative) Protective Type I

Annex C (normative) Protective Type II

Annex D (normative) Protective Type III

Annex E (normative) Two-hand control device for the mould area

Annex F (normative) Acknowledgement system

Annex G (normative) Use of proportional valves for the platen movement

Annex H (informative] Warning signs, prohibition signs and mandatory action signs

Annex I (normative) Noise test code

Bibliography