ДСТУ CLC/TS 60034-20-1:2022 Машини електричні обертові. Частина 20-1. Керувальні двигуни. Крокові двигуни (CLC/TS 60034-20-1:2004, IDT; IEC/TS 60034-20-1:2002, IDT)



ДСТУ CLC/TS 60034-20-1:2022
(CLC/TS 60034-20-1:2004, IDT; IEC/TS 60034-20-1:2002, IDT)

Машини електричні обертові. Частина 20-1.
Керувальні двигуни. Крокові двигуни

 
   
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

CONTENTS

FOREWORD

1 Scope

2 Normative references

3 Definitions

4 Symbols for quantities and their units

5 Dimensions

5.1 Type 1 motors (based on metric dimensions)

5.2 Type 2 motors (based on imperial dimensions)

6 Test methods and acceptance criteria

6.1 Shaft extension run-out, concentricity of spigot diameter and perpendicularity of mounting face to shaft

6.2 Moment of inertia of rotor

6.3 Voltage withstand test

6.4 Thermal resistance R_th and thermal time constant τ_th

6.5 Back e.m.f. constant

6.6 Motor inductance

6.7 DC resistance

6.8 Step angle error

6.9 Detent torque

6.10 Holding torque

7 Special tests

7.1 General

7.2 Winding temperature rise

7.3 Torque displacement curve

7.4 Single step response, natural frequency and settling time

7.5 Maximum slew rate

7.6 Pull-in rate

7.7 Pull-out torque

7.8 Maximum reversing rate

7.9 Resonance

8 Rating plate and other information

8.1 Rating plate

8.2 Typical modes

8.3 Values to be indicated by the manufacturer

8.4 Lead identification and terminal numbering

8.5 Catalogue presentation

8.6 Basic performance curves

9 EMC requirements

10 Safety requirements

Annex A (Informative) Test procedures

Annex В (Informative) Special tests

Annex ZA (normative) Normative references to international publications with their corresponding European publications