ДСТУ EN 13445-5:2022 Посудини, які працюють під тиском, без вогневого підведення теплоти. Частина 5. Перевірка та випробування (EN 13445-5:2021, IDT)



ДСТУ EN 13445-5:2022
(EN 13445-5:2021, IDT)

Посудини, які працюють під тиском, без вогневого
підведення теплоти. Частина 5. Перевірка та випробування

 

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

1 Scope

2 Normative references

3 Terms and definitions

4 Performance of inspection and testing

4.1 General

4.2 Inspection

4.3 Non-destructive testing (NDT)

5 Technical documents

5.1 General

5.2 Information to be contained in the technical documents

5.3 Design review

6 Inspection and testing during fabrication

6.1 General

6.2 Manufacturing procedures and construction drawings

6.3 Material traceability

6.4 Preparation for manufacturing processes

6.5 Welding

6.6 Non-destructive testing of welded joints

6.7 Destructive testing

6.8 Heat-treatment

7 Subcontracted items

7.1 General

7.2 Subcontracted welding related activities

7.3 Subcontracted non-destructive testing activities

8 Miscellaneous tests

9 Calibration

9.1 General

9.2 Calibration procedure

9.3 Identification

9.4 Registration

10 Final assessment

10.1 General

10.2 Extent of final assessment

11 Marking and declaration of compliance with the standard

11.1 General

11.2 Marking method

11.3 Marking units

11.4 Marking contents

11.5 Declaration of compliance with the standard

12 Documents

12.1 Type of documents

12.2 Control and access of documents

12.3 Retention of documents

Annex A (normative) Inspection and testing of serially produced pressure vessels

Annex В (normative) Detailed dimensional requirements for pressure vessels

Annex C (normative) Access and inspection openings, closing mechanisms and special locking elements

Annex D (informative) Leak Testing

Annex E (informative) Acoustic emission

Annex F (normative) Inspection and testing of pressure vessels or parts subject to creep

Annex G (normative) Inspection and testing of pressure vessels subject to cyclic loads

Annex H (informative) Declaration of compliance with this standard

Annex I (informative) Specific tests during construction to assist in-service inspection

Annex Y (informative) History of EN 13445-5

Annex ZA (informative) Relationship between this European Standard and the essential requirements of Directive 2014/68/EU aimed to be covered

Bibliography