ДСТУ CEN/TR 13445-102:2022 Посудини, які працюють під тиском, без вогневого підведення теплоти. Частина 102. Приклад застосування вертикальної посудини з кронштейнами (CEN/TR 13445-102:2015, IDT)

ДСТУ CEN/TR 13445-102:2022
(CEN/TR 13445-102:2015, IDT)

Посудини, які працюють під тиском, без вогневого підведення теплоти.
Частина 102. Приклад застосування вертикальної посудини з кронштейнами

 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 The vessel and its operating conditions

3.1 Drawing of the vessel

3.2 Calculation model

3.3 Operating conditions

3.4 Comments on the operating conditions provided by the User

4 Application of EN 13445-1

4.1 General

4.2 Is EN 13445 applicable to the vessel?

4.3 Warning of Annex A of reference [1]

4.4 Prerequisites of Annex A of reference [1]

5 Application of EN 13445-2

5.1 Permitted materials

5.2 Requirements given in 4.2 of reference [2]

5.3 Requirements given in 4.3 of reference [2]

5.4 Requirements given in 4.4 of reference [2]

5.5 Materials selected for the vessel example 2

6 Application of EN 13445-3

6.1 General

6.2 Basic design

6.3 Fatigue calculations

6.4 Determination of test pressures of the vessel in Annex C

6.5 Determination of the deformation according to EN 13445-4 reference [4], Clause 9 in Annex C

6.6 Data used in example 2

6.7 Conditions of applicability of calculations

7 Application of EN 13445-4

7.1 General

7.2 Material traceability

7.3 Manufacturing tolerances

7.4 Welding, as in 7 of reference [4]

7.5 Welding, as in 8 of reference [4]

7.6 Manufacture and testing of welds - Production test, as in 8 of reference [4]

7.7 Forming of pressure parts, as in 9 of reference [4]

7.8 Post weld heat treatment (PWHT), as in 10 of reference [4]

8 Application of EN 13445-5

8.1 Generality

8.2 Non destructive testing, as in 4.3 of reference [5]

8.3 Determination of extent of non-destructive testing, as in 6.6.2 of reference [5]

Annex A (informative) Drawing of example 2

Annex B (informative) Nameplate of example 2

Annex C (informative) Design calculation of example 2