ДСТУ EN 15383:2022 Системи пластикових трубопроводів для дренажу та каналізації. Армовані склопластики (GRP) на основі поліефірної смоли (UP). Люки та оглядові камери (EN 15383:2012+A1:2013, IDT)



ДСТУ EN 15383:2022
(EN 15383:2012+A1:2013, IDT)

Системи пластикових трубопроводів для
дренажу та каналізації. Армовані
склопластики (GRP) на основі
поліефірної смоли (UP). Люки та
оглядові камери

 
   
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

1 Scope

2 Normative references

3 Terms, definitions and symbols

4 General requirements

4.1 Classification

4.1.1 Categories

4.1.2 Nominal stiffness

4.2 Materials for shaft or chamber units

4.2.1 General

4.2.2 Elastomers

4.2.3 Metals

4.3 Reference conditions for testing

4.3.1 Temperature

4.3.2 Properties of water for testing

4.3.3 Loading conditions

4.3.4 Preconditioning

4.3.5 Measurement of dimensions

4.4 Joints

4.4.1 Types of joint

4.4.2 Length and diameter of joint

4.4.3 Flexibility of the jointing system

4.4.4 Scaling ring

4.4.5 Adhesives

4.5 Joint oerformance

4.5.1 Performance requirements

4.5.2 Interchangeability

4.5.3 Test pieces

4.5.4 Number of test pieces for type test purposes

4.5.5 Test temperature

4.5.6 Flexible joints with elastomeric sealing rings

4.5.7 Rigid joints of the wrapped or cemented type

4.5.8 Test parameters

5 Geometrical characteristics

5.1 Diameter, wall thickness and length of GRP-UP shaft and chamber components — Dimensional requirement

5.2 Size of openings in manholes

6 Mechanical characteristics

6.1 General

6.2 Longitudinal compressive strength

6.2.1 Initial longitudinal compressive stress at break

6.2.2 Requirements

6.3 Longitudinal compressive load

6.3.1 General

6.3.2 Ultimate longitudinal load, F_ult

6.3.3 Manufacturer's declared load for which a manhole or inspection chamber ring is designed, F_j and the permissible force, F_perm, p

7 Leak-tightness of manholes and inspection chambers and their joints

8 Minimum required marking

9 Ancillary products

9.1 Manhole and inspection chamber tops

9.2 Manhole steps and ladders

9.2.1 Location of steps

9.2.2 Load bearing capacity of installed steps

9.3 Precast concrete components

10 Dangerous substances

11 Manufacturer’s installation recommendations

12 Evaluation of conformity

Annex A (normative) Determination of the longitudinal compressive properties measured on prism shaped test pieces

Annex В (normative) Determination of the resistance of installed steps to vertical or horizontal loading