ДСТУ EN 13108-9:2022 Бітумні суміші. Специфікації матеріалів. Частина 9. Асфальт для ультратонкого шару (AUTL) (EN 13108-9:2016, IDT)



ДСТУ EN 13108-9:2022
(EN 13108-9:2016, IDT)

Бітумні суміші. Специфікації матеріалів. Частина 9.
Асфальт для ультратонкого шару (AUTL)

 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

European foreword

Introduction

1 Scope

2 Normative references

3 Terms, definitions, symbols and abbreviations

3.1 Terms and definitions

3.2 Symbols and abbreviations

4 Requirements for constituent materials

4.1 General

4.2 Binder

4.2.1 General

4.2.2 Selection of binder

4.3 Aggregates

4.3.1 Coarse aggregate

4.3.2 Fine aggregate

4.3.3 All-in aggregates

4.3.4 Added filler

4.4 Reclaimed asphalt

4.5 Additives

5 Requirements for the mixture

5.1 General

5.2 Composition, grading, binder content

5.2.1 Composition

5.2.2 Grading

5.2.3 Minimum binder content

5.3 Properties

5.3.1 Specimens

5.3.2 Void content

5.3.3 Water sensitivity

5.3.4 Low temperature properties

5.3.5 Friction after polishing

5.3.6 Coating and homogeneity

5.3.7 Reaction to fire

5.3.8 Resistance to fuel for application on airfields

5.3.9 Resistance to de-icing fluid for application on airfields

5.4 Temperature of the mixture

5.5 Regulated dangerous substances

5.6 Conflicting requirements

6 Assessment and verification of constancy of performance — AVCP

7 Identification

Annex A (normative) Calculations of the penetration or the softening point of the binder of a mixture when reclaimed asphalt is used

A.1 General

A.2 Calculation of the penetration of the binder of a mixture

A.3 Calculation of the softening point of the binder of a mixture

Annex ZA (informative) Relationship of this European Standard with Regulation (EU) No. 305/2011

ZA.1 Scope and relevant characteristics

ZA.2 System of Assessment and Verification of Constancy of Performance (AVCP)

ZA.3 Assignment of AVCP tasks

Bibliography