ДСТУ EN 528:2014 Устатковання на рейковому ходу для укладки та видачі вантажів зі складу. Вимоги щодо безпеки (EN 528:2008, IDT)

ДСТУ EN 528:2014
(EN 528:2008, IDT)

Устатковання на рейковому ходу
для укладки та видачі вантажів зі складу.
Вимоги щодо безпеки

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 List of significant and relevant hazards

5 Safety requirements and/or protective measures for all types of S/R machines

5.1 Introduction

5.2 Control position

5.3 Control equipment

5.4 Hoist unit

5.5 Travel unit.

5.6 Load handling devices

5.7 Electrical equipment

5.8 Transfer device

5.9 Maintenance repair and fault clearance

5.10 Machine environment

6 Additional requirements for manual operated machines

6.1 General

6.2 Onboard control position

6.3 Control equipment

6.4 Hoist unit

6.5 Acceleration and deceleration

6.6 Protection of operators in an aisle containing two or more manually operated machines

7 Particular requirements for machines without an on-board operator

7.1 General

7.2 External control position (control desk)

7.3 Control equipment

7.4 Hoist unit

7.5 Load handling devices

7.6 Escape

8 Installation

8.1 Erection and dismantling on site

8.2 Commissioning

9 Verification of safety requirements and/or measures

9.1 Examination

9.2 Written record

9.3 EMC

9.4 Noise

9.5 Load tests

10 Information for use

10.1 General

10.2 Instruction handbook

10.3 Minimum markings

10.4 Conditions for the safe operation of equipment

10.5 Maintenance, inspection and testing

Annex A (informative) Illustration of types of machines and transfer equipment

2Annex В (informative) Means of separation within racking

Annex C (normative) Safety levels according to EN ISO 13849-1

Annex D (informative) Examples for the design of load entry/exit points to prevent or deter access to danger areas or protect persons in accordance with 5.10.4

Annex E (normative) Verification of safety requirements and/or measures

Annex ZA (informative) Relationship between this European Standard and the Essential Requirements of EU Directive Machinery 98/37/EC

Annex ZB (informative) Relationship between this European Standard and the Essential Requirements of EU Directive Machinery 2006/42/EC

Bibliography