ДСТУ EN ISO 9445-2:2022 Непрерывно холоднокатаная нержавеющая сталь. Допуски на размеры и форму. Часть 2. Широкая полоса и плита/лист (EN ISO 9445-2:2010, IDT; ISO 9445-2:2009, IDT)

ДСТУ EN ISO 9445-2:2022
(EN ISO 9445-2:2010, IDT; ISO 9445-2:2009, IDT)

Безперервно холоднокатана нержавіюча сталь. Допуски на розміри та форму.
Частина 2. Широка смуга та плита/лист

 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

1 Scope

2 Normative references

3 Terms and definitions

4 Information to be supplied by the purchaser

5 Type of delivery and delivery condition

6 Preferred thicknesses

7 Tolerances on thickness for cold-rolled wide strip and products obtained from cold-rolled wide strip

8 Tolerances on width for cold-rolled wide strip and products obtained from cold-rolled wide strip

9 Preferred coil inner diameters for cold-rolled wide strip and slit cold-rolled wide strip

10 Tolerances on length for plate/sheet cut from cold-rolled wide strip and for cut lengths obtained from slit cold-rolled wide strip

11 Tolerances on edge camber for cold-rolled wide strip and products obtained from cold-rolled wide strip

12 Tolerances on squareness for plate/sheet obtained from cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip

13 Tolerances on flatness for plate/sheet obtained from cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip

14 Edge waviness tolerances for cold-rolled strip

15 Form of coils

16 Ordered format for plate/sheet and cut lengths

17 Measurement of thickness for cold-rolled wide strip, plate/sheet cut from cold-rolled wide strip, slit cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip

18 Measurement of width

19 Measurement of length

20 Measurement of edge camber

21 Measurement of squareness

22 Measurement of flatness and waviness.