ДСТУ EN ISO 9445-2:2022 Безперервно холоднокатана нержавіюча сталь. Допуски на розміри та форму. Частина 2. Широка смуга та плита/лист (EN ISO 9445-2:2010, IDT; ISO 9445-2:2009, IDT)
ДСТУ EN ISO 9445-2:2022
(EN ISO 9445-2:2010, IDT; ISO 9445-2:2009, IDT)
Безперервно холоднокатана нержавіюча сталь. Допуски на розміри та форму.
Частина 2. Широка смуга та плита/лист
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)
Contents
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Information to be supplied by the purchaser
5 Type of delivery and delivery condition
6 Preferred thicknesses
7 Tolerances on thickness for cold-rolled wide strip and products obtained from cold-rolled wide strip
8 Tolerances on width for cold-rolled wide strip and products obtained from cold-rolled wide strip
9 Preferred coil inner diameters for cold-rolled wide strip and slit cold-rolled wide strip
10 Tolerances on length for plate/sheet cut from cold-rolled wide strip and for cut lengths obtained from slit cold-rolled wide strip
11 Tolerances on edge camber for cold-rolled wide strip and products obtained from cold-rolled wide strip
12 Tolerances on squareness for plate/sheet obtained from cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip
13 Tolerances on flatness for plate/sheet obtained from cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip
14 Edge waviness tolerances for cold-rolled strip
15 Form of coils
16 Ordered format for plate/sheet and cut lengths
17 Measurement of thickness for cold-rolled wide strip, plate/sheet cut from cold-rolled wide strip, slit cold-rolled wide strip and cut lengths obtained from slit cold-rolled wide strip
18 Measurement of width
19 Measurement of length
20 Measurement of edge camber
21 Measurement of squareness
22 Measurement of flatness and waviness.
Повна версія документа доступна в тарифі «ВСЕ ВРАХОВАНО».