ДСТУ EN 60317-0-1:2022 Технические условия для отдельных типов обмоточных проводов. Часть 0-1. Общие требования. Эмалированная круглая медная проволока (EN 60317-0-1:2014, IDT; IEC 60317-0-1:2013, IDT)



ДСТУ EN 60317-0-1:2022
(EN 60317-0-1:2014, IDT; IEC 60317-0-1:2013, IDT)

Технічні умови для окремих типів обмотувальних дротів.
Частина 0-1. Загальні вимоги. Емальований круглий мідний дріт

 

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Introduction

1 Scope

2 Normative references

3 Terms, definitions, general notes and appearance

3.1 Terms and definitions

3.2 General notes

3.3 Appearance

4 Dimensions

4.1 Conductor diameter

4.2 Out of roundness of conductor (nominal conductor diameters over 0,063 mm)

4.3 Minimum increase in diameter due to the insulation and the bonding layer (nominal conductor diameters over 0,063 mm)

4.4 Maximum overall diameter

5 Electrical resistance

6 Elongation

7 Springiness

7.1 Nominal conductor diameters from 0,080 mm up to and including 1,600 mm

7.2 Nominal conductor diameters over 1,600 mm

8 Flexibility and adherence

8.1 Mandrel winding test (nominal conductor diameters up to and including 1,600 mm)

8.2 Stretching test (nominal conductor diameters over 1,600 mm)

8.3 Jerk test (nominal conductor diameters up to and including 1,000 mm)

8.4 Peel test (nominal conductor diameters over 1,000 mm)

9 Heat shock

9.1 Nominal conductor diameters up to and including 1,600 mm

9.2 Nominal conductor diameters over 1,600 mm

10 Cut-through

11 Resistance to abrasion

12 Resistance to solvents

13 Breakdown voltage

13.1 General

13.2 Nominal conductor diameters up to and including 0,100 mm

13.3 Nominal conductor diameters over 0,100 mm up to and including 2,500 mm

13.4 Nominal conductor diameters over 2,500 mm

14 Continuity of insulation (nominal conductor diameters up to and including 1,600 mm)

15 Temperature index

16 Resistance to refrigerants

17 Solderability

18 Heat or solvent bonding

19 Dielectric dissipation factor

20 Resistance to transformer oil

21 Loss of mass

23 Pin hole test

30 Packaging

Annex A (informative) Dimensions for intermediate nominal conductor diameters (R 40)

Annex B (informative) Method for the calculation of linear resistance

Annex C (informative) Resistance

Bibliography