ДСТУ EN 50342-1:2022 Свинцово-кислотные стартерные батареи. Часть 1. Общие требования и методы испытаний (EN 50342-1:2015, IDT)

ДСТУ EN 50342-1:2022
(EN 50342-1:2015, IDT)

Свинцево-кислотні стартерні батареї. Частина 1.
Загальні вимоги та методи випробування

 
   
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

European foreword

1 Scope

2 Normative references

3 General

3.1 Introduction

3.2 Designation of starter batteries

3.3 Condition on delivery

3.3.1 Specific gravity of electrolyte and open circuit voltage

3.3.2 Definition of fully charged new battery

3.4 Electrical characteristics

3.5 Mechanical characteristics

4 General requirements

4.1 Identification, labelling

4.2 Marking of the polarity

5 General test conditions

5.1 Sampling of batteries

5.2 Charging method - Definition of a fully-charged battery

5.3 Test equipment

5.3.1 Measuring instruments

5.3.2 Water bath

5.4 Test sequence

6 Test methods and requirements

6.1 Capacity check C_в

6.2 Cranking performance test

6.3 High current discharge test at low temperature

6.4 Charge acceptance test

6.5 Charge retention test

6.6 Endurance in cycle test

6.7 Corrosion test

6.8 Deep discharge test

6.9 Water consumption test

6.10 Vibration resistance test

6.11 Electrolyte retention test

6.11.1 Vented batteries

6.11.2 Valve regulated batteries

7 Dry-charged batteries

7.1 General

7.2 Activation of dry charged batteries

7.3 Testing of dry charged batteries

Annex A (normative) Safety labelling - Definition of the six coloured symbols

Annex B (normative) Correlation between C20 and RC

Annex C (normative) Battery performance marking

Bibliography