ДСТУ EN 1366-10:2022 Испытания на огнестойкость для сервисных установок. Часть 10. Клапаны контроля дыма (EN 1366-10:2011+A1:2017, IDT)



ДСТУ EN 1366-10:2022
(EN 1366-10:2011 + A1:2017, IDT)

Випробування на вогнестійкість для сервісних установок.
Частина 10. Клапани контролю диму

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

European foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 Test equipment

4.1 General

4.2 Connecting duct for multi compartment fire resisting smoke control damper: maintenance of opening test and EN 1366-2 test

4.3 Volume flow measuring station for multi compartment fire resisting smoke control damper: maintenance of opening test and EN 1366-2 test

4.4 Plenum for High Operating Temperature (HOT) test

4.5 Cycling equipment

4.6 Condensing unit

4.7 Gas temperature measuring devices

4.8 Exhaust fan system

4.9 Perforated plate

4.10 Flow measurement nozzles (fire test)

4.11 Ambient leakage measuring device

4.12 Pressure sensors for differential pressure control

4.13 Welded connecting tube

4.14 Extract fan connecting duct

4.15 Extraction fan

4.16 Thermocouples

4.17 Oxygen measuring equipment

4.18 Observation windows

5 Test specimen

5.1 Cross-section

5.2 Design

6 Test methods

6.1 General

6.2 Initiation regimes for elevated temperature and fire tests

6.3 Cycling test requirements (to form part of the sequences of testing defined below)

6.4 Single compartment smoke control dampers mounted on the surface of a duct

6.5 Multi compartment fire resisting smoke control dampers

6.6 Multi compartment fire resisting smoke control dampers (HOT Classification)

7 Test procedure

7.1 Pre-test calibration

7.2 Fire test

7.3 Termination of test

8 Test report

9 Direct field of application of test results

9.1 General

9.2 Smoke control damper sizes

9.3 Pressure difference

9.4 Elevated temperatures

9.5 Cycling tests

9.6 Initiation method

9.7 Application to duct constructions other than that tested

Annex A (normative) Cycling test

Annex B (normative) Leakage calculation from oxygen measurement

Annex C (normative) Maintenance of opening calculation

Bibliography