ДСТУ EN 12101-13:2022 Системы управления дымом и теплом. Часть 13. Системы перепада давления (PDS). Методы проектирования и расчета, установки, приемные испытания, плановое испытание и техническое обслуживани...

ДСТУ EN 12101-13:2022
(EN 12101-13:2022, IDT)

Системи управління димом і теплом. Частина 13. Системи перепаду тиску (PDS). Методи проєктування та розрахунку, встановлення, приймальні випробування, планове випробування та технічне обслуговування

 
   
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

European foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 Design objectives

4.1 General

4.2 Protection of means of escape

4.3 Protection of firefighting routes

4.4 Property protection

4.5 Additional functions

5 Normative requirements

5.1 General

5.2 Application of Class 1 and Class 2

5.3 Response delay - time period definitions

5.4 Door opening force

5.5 Pressure differential systems

5.6 Pressurization systems

6 Interaction

6.1 General

6.2 Requirements

7 Equipment and components - specification and installation

7.1 General

7.2 Software based fire control systems

7.3 Automatic control of a PDS

7.4 Manual control of a PDS

7.5 Description of components and their requirements

8 Testing and measuring

8.1 General

8.2 Preconditions

8.3 Tests

8.4 Minimum number of tests; floor positions and other information

8.5 Test procedures

9 Additional considerations for design and testing

9.1 General

9.2 Parameters for consideration during design and performance testing

10 Documentation

10.1 General

10.2 Requirements by the authorities having jurisdiction

10.3 Technical description of the PDS

10.4 "As built/installed" information

10.5 Controls

10.6 Components list (inventory) and datasheets

10.7 Completion certification

11 Testing and Maintenance, design changes, faults, routine testing and operation

11.1 General

11.2 Records

11.3 Building design changes

11.4 Faults

11.5 Routine testing

11.6 Maintenance

Annex A (informative) Calculation procedures

Annex B (informative) Design example and possible calculation procedures

Annex C (informative) Further information on wind and temperature effects

Annex D (informative) Guidance for PDS design for buildings taller than 60m

Annex E (informative) (Example) PDS drawing

Annex F (informative) Documentation and responsibilities in the process

Annex G (informative) (Example) PDS concept report

Annex H (informative) (Example) PDS test report

Annex I (informative) Risk assessment - List of potential disturbances

Annex J (informative) Practical suggestions for successful commissioning

Annex K (normative) Labelling

Bibliography