ДСТУ CLC/TS 50131-2-10:2014 Системы тревожной сигнализации. Системы охранной сигнализации. Часть 2-10. Извещатели охранные контактные блокировки (CLC/TS 50131-2-10:2014, IDT)

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Наказом Міністерства економічного розвитку і торгівлі України
від 30.12.2014 № 1494

CLC/TS 50131-2-10:2014

en: Alarm systems - Intrusion and hold-up systems -
Part 2-10: Intrusion detectors- Lock state contacts (magnetic)

прийнято як національний стандарт
методом підтвердження за позначенням

ДСТУ CLC/TS 50131-2-10:2014

uk: Системи тривожної сигналізації. Системи охоронної сигналізації.
Частина 2-10. Сповіщувачі охоронні контактні блокування
(CLC/TS 50131-2-10:2014, IDТ)

З наданням чинності від 2016-01-01

Contents

Foreword                            

Introduction

1 Scope

2 Normative references

3 Terms, definitions and abbreviations

3.1 Terms and definitions 

3.2 Abbreviations

4 Functional requirements

4.1 Events

4.2 Signals or messages

4.3 Detection

4.4 Operational requirements

4.5 Tamper security

4.6 Electrical requirements

4.7 Environmental classification and conditions

5 Marking, identification and documentation

5.1 Marking and/or identification

5.2 Documentation

6 Testing

6.1 Generalities

6.2 General test conditions

6.3 Basic test of detection capability

6.4 Verification of detection performance

6.5 Switch-on delay, time interval between signals, and indication of detection

6.6 Tamper security

6.7 Electrical tests

6.8 Environmental classification and conditions

6.9 Marking, identification and documentation

Annex A (normative) Dimensions & requirements of standardized interference test magnets

Annex В (normative) General testing matrix

Annex С (informative) List of small tools suitable for testing immunity of casing to unauthorised access

Annex D (normative) Axes of movement 

Annex E (normative) Test surfaces for ferromagnetic material

Annex F (normative) Test faces for interference test units

Bibliography

Figures

Figure A.1 — Test magnet for surface mount opening magnetic contacts

Figure A.2 — Test magnet for flush mount opening magnetic contacts

Figure D.1 — Flush mount style

Figure D.2 — Surface mount style

Figure F.1 — Surface mount interference test, interference test unit

Figure F.2 — Surface mount interference test, interference test unit I purely magnetic

Figure F.3 — Flush mount interference test, interference test unit (unshaded), corresponding unit (shaded)

Tables

Table 1 — Events to be processed and main functions to be provided by grade

Table 2 — Generation of signals or messages

Table 3 — Electrical requirements

Table 4 — Environmental tests, operational

Table 5 — Environmental tests, endurance

Table B.1 — General testing matrix