ДСТУ EN 14492-2:2019 Краны грузоподъемные. Лебедки и тали с механическим приводом. Часть 2. Тали с механическим приводом (EN 14492-2:2019, IDT)

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(   
(ДП «УкрНДНЦ»))

Наказ від 21.08.2019 № 271

EN 14492-2:2019

Cranes —
Power driven winches and hoists —
Part 2: Power driven hoists

прийнято як національний стандарт
методом «підтвердження» за позначенням
 

ДСТУ EN 14492-2:2019
(EN 14492-2:2019, IDT)

Крани вантажопідіймальні.
Лебідки та талі з механічним приводом.
Частина 2. Талі з механічним приводом

З наданням чинності від 2020–01–01

Contents

European foreword

Introduction

1 Scope

2 Normative references

3 Terms, definitions and symbols

3.1 Terms and definitions

3.2 Symbols and abbreviations

4 List of significant hazards

5 Safety requirements and/or protective measures

5.1 General

5.2 Devices

5.3 Couplings

5.4 Brakes for hoisting and lowering movements

5.5 Gearbox

5.6 Load hooks

5.7 Rope drives

5.8 Chain drives

5.9 Belt drives

5.10 Pneumatic equipment

5.11 Hydraulic equipment

5.12 Trolleys

5.13 Electrical equipment of hoists and their trolleys

5.14 Reduction of noise by design

5.15 Hoists for use in potentially explosive atmosphere

5.16 Equipment for warning

6 Verification of the safety requirements and/or protective measures

6.1 Hoists manufactured in series

6.2 Hoists designed individually

7 User information

7.1 General

7.2 Special requirements

7.3 Marking

Annex A (informative) Examples of power driven hoists

Annex B (normative) Classification

Annex C (informative) Guidance on hoist classification

Annex D (normative) Additional requirements for high risk applications

Annex E (normative) Additional requirements for Power driven hoists designed for holding stationary loads above persons

Annex F (normative) Additional requirements for hoists intended to be used in potentially explosive atmospheres

Annex G (informative) Additional requirements for operation in aggressive environments and outdoors

Annex H (informative) Additional requirements for operation at low temperatures

Annex I (normative) Supporting structures for NGL building hoists

Annex J (normative) Power driven series hoist mechanisms - Test procedure for

Annex K (informative) Values of ϕ_IAL, ϕ_DAL for different types of rated capacity limiters

Annex L (informative) Number of starts and cyclic duration factor of motors

Annex M (normative) Noise test code

Annex N (normative) Design calculation parameters for chains

Annex O (informative) Selection of a suitable set of crane standards for a given application

Annex ZA (informative) Relationship between this European Standard and the Essential Requirements of EU Directive 2006/42/EC aimed to be covered

Annex ZB (informative) Relationship between this European Standard and the Essential Requirements of EU Directive 2014/34/EU aimed to be covered

Bibliography