ДСТУ EN 15061:2014 Безопасность машин. Требования безопасности для линий потоковой обработки планок машин и оборудования (EN 15061:2007+A1:2008, IDT)

ДСТУ EN 15061:2014
(EN 15061:2007+A1:2008, IDT)

Безпечність машин.
Вимоги щодо безпеки для ліній
потокового оброблення планок машин і устатковання

 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 List of significant hazards

5 Safety requirements and/or measures

5.1 General design requirements

5.2 List of significant hazards, hazardous situations, safety requirements and/or measures for terminal equipment

5.3 List of significant hazards, hazardous situations, safety requirements and/or measures for processing equipment

5.4 Special safety requirements or measures

5.5 Noise reduction as a safety requirement

6 Verification of the safety requirements and/or measures

7 Information for use

7.1 General

7.2 Safety signs and warning devices

7.3 Minimum marking

7.4 Instruction handbook

7.5 Maintenance manual

Annex A (normative) Safety requirements and/or measures for electrical equipment

Annex В (normative) Noise test code

Annex C (informative) Example for manufacturer's safety instructions for maintenance at strip processing lines

Annex D (informative) Exemplary solutions

Annex ZA (informative) Relationship between this European Standard and the Essential Requirements of EU Directive 98/37/EC

Annex ZB (informative) Relationship between this European Standard and the Essential Requirements of EU Directive 2006/42/EC

Bibliography