ДСТУ EN 14246:2019 Элементы гипсовые для подвесных потолков. Определения, требования и методы испытаний (EN 14246:2006, IDT)

Данный документ доступнен в тарифе «ВСЕ ВКЛЮЧЕНО»

У Вас есть вопросы по документу? Мы рады на них ответить!Перечень бесплатных документовОбнаружили ошибку в документе или на сайте? Пожалуйста, напишите нам об этом!Оставить заявку на документ

ПІДТВЕРДЖУВАЛЬНЕ ПОВІДОМЛЕННЯ

Державне підприємство
«Український науково-дослідний і навчальний центр
проблем стандартизації, сертифікації та якості»
(   
(ДП «УкрНДНЦ»))

Наказ від 23.12.2019 № 479

EN 14246:2006

Gypsum elements for suspended ceilings —
Definitions, requirements and test methods

прийнято як національний стандарт
методом «підтвердження» за позначенням
 

ДСТУ EN 14246:2019
(EN 14246:2006, IDT)

Елементи гіпсові для підвісних стель.
Визначення, вимоги та методи випробування

З наданням чинності від 2020–01–01

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 Types of gypsum ceiling elements for suspended ceilings

4.1 General

4.2 Gypsum units

4.3 Gypsum tiles

5 Requirements

5.1 Fire behaviour

5.2 Water vapour permeability (expressed as water vapour resistance factor)

5.3 Flexural strength (expressed as flexural breaking load)

5.4 Acoustic properties

5.5 Thermal properties — Thermal resistance (expressed as thermal conductivity)

5.6 Regulated substances

5.7 Appearance

5.8 Dimensions and tolerances

5.9 Squareness

5.10 Flatness (not for tiles with decorative face)

5.11 Mass per unit of surface and tolerance

5.12 Moisture content

5.13 pH

6 Test methods

6.1 Sampling

6.2 Preparation of the test specimens

6.3 Determination of flexural strength

6.4 Determination of surface appearance

6.5 Measurement of dimensions

6.6 Determination of squareness

6.7 Determination of flatness (not for gypsum elements with decorated faces)

6.8 Determination of the mass per surface unit

6.9 Determination of the moisture content

6.10 pH measurement

6.11 Test report

7 Evaluation of conformity

7.1 General

7.2 Type testing

7.3 Factory production control (FPC)

8 Designation

9 Marking, labelling and packaging

Annex A (informative) Sampling procedure for testing

Annex ZA (informative) Clauses of this European Standard addressing provisions of EU Construction Products Directive

Bibliography

Полная версия документа доступна в тарифе «ВСЕ ВКЛЮЧЕНО».

Войти в Личный кабинет Подробнее о тарифах

БУДСТАНДАРТ Online