ДСТУ EN 17059:2019 Линии нанесения гальванических и анодированных покровов. Требования безопасности (EN 17059:2018, IDT)

ДСТУ EN 17059:2019
(EN 17059:2018, IDT)

Лінії нанесення гальванічних і анодувальних покривів.
Вимоги щодо безпеки

 
   
 
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

European foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 Requirements

4.1 General

4.2 Mechanical safety requirements

4.3 Electrical safety requirements

4.4 Safety requirements and protective measures against thermal hazards

4.5 Safety requirements and protective measures against noise

4.6 Hazardous substances

4.7 Safety measures against fire

4.8 Safety requirements against hazards by failure of energy supply or control

4.9 Safety requirements for control systems

5 Determination of compliance with safety requirements and / or protective measures

5.1 General

5.2 Mechanical hazards

5.3 Electrical hazards

5.4 Thermal hazards

5.5 Noise

5.6 Hazardous substances

5.7 Fire

5.8 Failure of energy supply

5.9 Safety requirements for control systems

6 Information for use

6.1 General

6.2 Instruction handbook

6.3 Marking

Annex A (informative) Significant hazards

Annex B (informative) Examples of transporter units

Annex C (informative) Examples of working areas

Annex D (normative) Calculation of airflow for tanks with lids and open tanks

Annex E (normative) Exhaustive list of the captured air velocities (mean speed) in the main bath used in plating and anodizing industry

Annex ZA (informative) Relationship between this European Standard and the essential requirements of Directive 2006/42/EC aimed to be covered

Bibliography