ДСТУ EN 289:2015 Оборудование для производства резины и пластмасс. Прессы. Требования безопасности (EN 289:2014, IDT)

ДСТУ EN 289:2015
(EN 289:2014, IDT)

Устатковання для виробництва гуми та пластмас.
Преси. Вимоги щодо безпеки

 
   
 
 
     
Не є офіційним виданням.
Офіційне видання розповсюджує національний орган стандартизації
(ДП «УкрНДНЦ» http://uas.gov.ua)

Contents

Foreword

Introduction

1 Scope

2 Normative references

3 Terms and definitions

4 List of significant hazards

4.1 General

4.2 Danger areas on presses

4.3 General hazards

4.4 Hazards in specific machine areas

4.5 Hazards associated with power operated mould clamping systems

4.6 Hazards associated with power operated mould changing equipment 

4.7 Additional hazards associated with specific design

4.8 Additional hazards when using ancillary equipment

5 Safety requirements and/or protective measures

5.1 General

5.2 Basic requirements for safeguards used on presses

5.3 Safety requirements and/or protective measures to prevent general hazards

5.4 Safety requirements and/or protective measures in specific machine areas

5.5 Safety requirements and/or protective measures for power operated mould clamping systems

5.6 Safety requirements and/or protective measures for power operated mould changing equipment

5.7 Additional safety requirements and/or protective measures associated with specific design

5.8 Additional safety requirements and/or protective measures when using ancillary equipment

6 Verification of the safety requirements and/or protective measures

7 Information for use

7.1 General

7.2 Instruction handbook

7.3 Marking

7.4 Warning signs and alarm signals

Annex A (normative) Acknowledgement systems

Annex B (normative) Noise test code

Annex ZA (informative) Relationship between this European Standard and the Essential Requirements of EU Directive 2006/42/EC

Bibliography